Guest February 28, 2011 How do you remove inner tub assembly on a maytag neptune mah4000aww washer? part number ap4028202
1 Answer SPINNER TUB SUPPORTThe spinner tub support attaches to the spin basket and the shaft of the spider extends through a seal system to the exterior of the outer tub with a pulley attached to the end of the shaft. This assembly supports the spin basket and transfers the rotation of the drive pulley directly to the rotation of the spin basket.NOTE: When the spinner tub support is removed, the shaft seal system should be replaced.REMOVAL1. Disconnect power to the unit.2. Remove the front panel, top cover, front shroud and outer tub cover.3. Remove the drive pulley.4. With the pulley removed, the spin basket with the spider shaft can be pulled from the frontof the outer tub assembly.5. To separate the spinner tub support from the spinner, remove the three rear baffles withinthe spin basket by removing the two screws securing each baffle.6. Remove the three locking nuts (½" socket) securing the spin basket to the spider assembly.7. Remove the shaft seal.REPLACEMENT1. Reverse the previous steps.2. IMPORTANT: Secure the three locking nuts (½" socket) on the spinner tub support studs(18 in. lbs. torque). Read More...
James February 20, 2011 Hey guys I hope you can help me with the issue I have. My washer broke on the inner rim section of the spinner which is only about 1/8 inch thick wall that broke causing to leak. I would like to know if this is the spinner assembly, or #17?
1 Answer This is the inner tub assembly. By what you are describing, you will need this part.22004475 Read More...