Maria June 06, 2012 for Model Number MAH4000AWW A repairman handed me a broken bolt that held the spinner support arm in place. He stated I would need a new arm. Wouldn't I just need a new bolt and not the total arm replaced?
1 Answer Hello Maria. No, the bolts are made onto the supports W10181639. You will need to order the support assembly if the bolt is broken. Read More...
Michael December 17, 2011 for Model Number mah3000aww Sounds like a jet engine at the start of spin cycle and has occassionaly been leaving a yellowish grease/oil residue on clothes
1 Answer Hi Michael. You will need to replace the support assy. part # W10181639. Molykote grease part # WP22002123. Outer tub assy. w/ bearings and seals part # 22004465. This way the support shaft will permanently seal new with the tub bearings and seal assy. Thank You. Read More...
Ed July 04, 2011 for Model Number MAH5500BWW My washer works properly, no leaks. The problem is that during the spin cycle and high speed spin it sounds like a jet airplane taking off. If it is the bearings, what other parts should be replaced at the time of repair?
1 Answer Hello Ed. Based on the information you provided, it sounds like the bearing is bad and will need to be replaced. You will need to replace the 22004465 outer tub assembly, and the support W10181639 if it is worn. Hope this helps. Read More...
Guest March 11, 2011 I have a Maytag Neptune and it would not spin the load after washing. I replaced the pulley, belt & 2 switches. It looks like it may have a broken bearing, would that cause the tub not to spin.
1 Answer Hello. If the bearing is bad , you will have spin problems. Also you could have a bad motor control board, spin switch, or out of balance switches. Check and make sure the door is locking as well. Hope this helps. Read More...
Guest March 01, 2011 my washer also makes alot of noise its a nuptune maytag it also sounds like bearings is the lip kit and bearings the same or do i have 2 order them different?
1 Answer In order to get the proper bearings you will need for this repair, you will need to order the outter tub assembly. 22004465 Read More...
Murray O February 28, 2011 Our washing machine makes a lot of noise when it is spinning. it sounds like a bearing or something is going bad.
1 Answer You can remove the access panel on the back of the washer, and inspect the tub bearing from there. Look for signs of a leak around it, also rotate the tub by hand, and see if there is dragging with the tub. Read More...