Sonny April 18, 2021 for Model Number CGM2941TQ1 My commercial whirlpool dryer has a connection between the motor and the coin box that was snapped during DIY installation. I notice if I shorted the blue wire without connecting it to the coin box which I assume is simply a relay which shorts it based on a timer, it runs fine. If I connect the coin box cable with this blue cable, I notice that the gas valve and ignitor would turn on but the motor would not start. Is the Switch-Pb at fault or is it something else?
1 Answer Sonny, We are not showing a control board on this unit and the blue wire would go back to the timer on the unit. We do not show wiring for the coin box that would connect to the blue wire on the motor.. Read More...
Greg August 20, 2018 for Model Number CG2951XSN3 My aunt depends on a old coin operated Whirlpool. After pushing in the coins, you can choose the heat setting, they light up. But when you push the start button, nothing happens. Should I replace the Switch-Pb? Thank you Greg
1 Answer Greg, unplug the dryer and check for continuity on the door switch, the switch should be closed with the door in the closed position. Check the thermal fuse located on the back of the dryer, down by the exhaust, it should be reading closed. Make sure the timer in the coin box is in the run position. Read More...
Michael July 18, 2017 for Model Number CGM2751KQ3 The wires were disconnected from the start and temp selector switch and I need to know which wires go where.
1 Answer Hello Michael. The push to start switch has black on COM and white with a red stripe on NO. The temp switch has Blue to SW1, Orange to SW2, Tan to SW3, Yellow to SW, Red to AH1, and Violet to AH2. Read More...
Nate August 19, 2014 for Model Number gcem2990tq1 I have a whirlpool dryer about 5 years old. it will only come on if I hold the start button in and then only for a few seconds and it shuts down. I think the switch is burnt?