Tim October 08, 2011 for Model Number 11026882500 When starting a cycle the water starts filling and stops pre maturely. I push the main control switch in and pull out again and it resumes filling. After doing this several times the wash cycle continues as normal.
1 Answer Hello Tim. Make sure both the hot and the cold water is working on the water valve WP3979346. If you set it to warm or hot and it goes to bring in hot water, and nothing comes, you will need to replace the water valve. If both valves work properly, then it sounds like the pressure switch W10339326 is bad and will need to be replaced. Hope this helps. Read More...
Dave May 25, 2011 for Model Number 110.28924790 My water level switch seems to stick, I ordered one from Sears, replaced it, and this seems to stick also. It came as a used switch, which I didn't notice in my haste to get one on order. If it goes overfull, I rap on the control panel, and it stops filling and continues to the next operation. Happened so many times I put a water level alarm on it, so now I catch it when it messes up. Could two switches both do this?
1 Answer Hello Dave. You will need to order the pressure switch W10339326 and replace the switch and the hose both. Hope this helps. Read More...
1 Answer Hello John! The water level switch W10339326 detects the amount of water entered into the tub and shuts the valve off once the water level selected has been reached. At that point it will then give a signal to turn the motor on for the wash cycle to start. Hope this helps! Read More...