Carl Pennebaker July 05, 2021 for Model Number MGDE300VF2 I power on the dry. Lights up with 40 min on the clock. Push start. it clicks and a few seconds later I get a Flashing F01. What part do I need? Instructions to replace the part or video you can refer me to to get to the part in the machine. Thank you.
1 Answer Carl P,Based on the information provided the F01 flashes when there is a primary control failure. part # WPW10174745 Video link: https://www.youtube.com/watch?v=GT7joi2Isgs Read More...
Richard November 09, 2014 for Model Number maytag MEDE300VW1 I have an F01 code on dryer. What part to I need.
1 Answer Richard, You will need the machine control board WPW10174745, located on the inside of the cabinet on the left side , above the drum. " F-01 PRIMARY CONTROL FAILURE F:01 flashes when there is a primary control failure. Replace the machine control electronics." You'll need to remove power to the dryer and remove the top panel to access it. Read More...
Mike January 21, 2014 for Model Number Mede300vf2 F01 code on maytag dryer can you tell me part that I need?
1 Answer Hello Mike. F:01 flashes when there is a primarycontrol failure.Replace the machine control electronics. Read More...
Jose April 03, 2013 for Model Number maytag dryer mod MGDE300VW1/panel board How do I know is the right one?
1 Answer Jose, The control board part number WPW10283492 is the correct control board for your unit. Read More...
John December 04, 2011 for Model Number MGDE300VW1 How do i replace the Control Board. Item #21 on the diagram above. Here: http://www.appliancepartspros.com/Appliance-Parts/whirlpool-cntrl-elec-item-number-ap4514568.aspx. The part number is ap4514568.
1 Answer Hello John. Disconnect the power to the unit. Remove the screws on the back of the top panel and slide the top panel toward the back and lift off the unit. Next remove the screws securing the control panel and unplug the wires for the panel. Remove the control panel from the unit. Now you can access and replace the control board WPW10283492. Reinstall in reverse order. Hope this helps. Read More...