Jackie November 09, 2012 for Model Number ED5PHAXSQ00 Refrigerator will run until temperature setting is satisfied. It will not come back on until I increase to a cooler setting. It will recycle sometimes and then not until I increase to a colder setting again. I think it is the temperature control. Am I correct?
1 Answer Hello Jackie, You are correct. The temperature control WP2315562 should kick back on by itself. When it doesn't, the only fix is to replace the temperature control. Read More...
Mike September 14, 2012 for Model Number ED2KHAXVBOO With Reference to Thermostat, I checked the One in my whirlpool Fridge and it working fine. ( as my fridge compressor keeps running even it reaches the correct running tempeture.I checked the Continuity and put the thermostat in Ice , It Clicked and turn off the continuity. There is circuit board near the Thermostat could it that and have any other idea what could check. Thank again for you help.
1 Answer Hello Mike. It is not working properly if it is not in the off position and the unit is at the correct temperature. You will need to order and replace the thermostat WP2315562 based on the information you provided. Read More...
Mike September 14, 2012 for Model Number ED2KHAXVBOO Hi there, I compressor keeps running even thou it reaches the correct tempature in Freezer and Fridge, I just had compressor replaced. How do check the Thermostat to see it it needs to replaced? I Have good meter. Thank you
1 Answer Hello Mike. If the compressor runs, and the unit is at the correct temperature, then it is the thermostat WP2315562 that needs to be replaced. This reads the temperature inside the unit and turns off and on the unit. Read More...
Roland April 05, 2012 for Model Number ED5FHAXSTO1 I received my order from you guys, part # ap3882436, every thing was fine installing it until I got to the coil. How do you insert the coil into the tubing?. I had a hard time and it bend and broke. I order me a new one but I need to know a better of installing it. thanks Roland
1 Answer Roland, Are you removing the diffuser cover 2152019 and diffuser WPW10151374 so you can access the end of the tube and plastic sheath ? You'll find it a lot easier if you uncoil and straighten most of the capillary tube, very carefully. then install evrything again. Good Luck and Thanks Read More...
Roland March 30, 2012 for Model Number ED5FHAXSTO1 Refrigerator & freezer not cooling enoungh, some times you need to bump the front control panel to make it start, but still not cold enough.
1 Answer Hello Roland. Based on the information you provided, it sounds like the thermostat WP2315562 needs to be replaced. Make sure they are no loose connections in the control panel. Hope this helps. Read More...
Jim December 19, 2011 for Model Number gd5yhaxtl00 My refrigerator is set at the lowest setting and still freezes up everything in the refrigerator. Is a bad themostat causing this problem. I cleaned the coils at the bottom of the refrigerator, they were dity.
1 Answer Hello Jim. Check and make sure the damper is opening and closing properly inside the unit. If so, then it sounds like the temperature control WP2315562 could be the issue with the unit and will need to be replaced. Hope this helps. Read More...
Art December 01, 2011 for Model Number ED2FHAXSQ00 can thermostat be tested for continuity with ohmeter or anything else ,if so how.I have replaced control unit evap. coils still freezing up.I tested defrost heater and bi-metal thermostat for continuity,and both look good.I'm thinking it almost has to be thermostat.What do you think?
1 Answer Hello Art. No, the thermostat WP2315562 does not deal with the defrost cycle. It has to be the heater or bi-metal or a bad wire in the unit. Re-test the heater without ice on the coils and test the bi-metal when cold. Hope this helps. Read More...
Jon May 02, 2011 for Model Number 10656999601 I'm pretty sure it's my thermostat that's busted. I just don't know how to get the control panel open. There are two main screws I can remove. But, those aren't the only one. Something on the inside also needs to be removed. http://www.searspartsdirect.com/partsdirect/part-model/Kenmore-Parts/Refrigerator-Parts/Model-10656999601/0582/0165000/K0609005/00009?blt=06&prst=0&shdMod=10656999601 This is the part I need help getting into.
1 Answer Hello Jon. You will need to remove the front Escutcheon W10124120. This is the front cover of the control panel. It unsnaps from the control panel. Once removed, you will see the screws holding the control panel in place. Hope this helps. Read More...