Carlos September 08, 2014 for Model Number 106-56612500 I bought a defrost timer kit SUPCO SPA1403FL for my Kenmore refrigerator model 106-56612500 it has the loose wire to connect on terminals 1 0r 2. In which terminal should I connect it to perform properly? Thanks in advance. Note, the timer has the number PSA140300. I thank you in advance.
Neck Hurts September 02, 2014 for Model Number ET8MTKXKQ02 What terminal does the black wire go on (no tech sheet)?
1 Answer Neck hurts, The black lead wire for the new timer will go to the number 1 terminal on the timer for your model. Read More...
Tizzle August 27, 2014 I have a top mount Whirlpool refrigerator that I've changed the timer and put the black jumper onto connecter 1. I've noticed the freezer would melt everything and freeze it back up again so I changed the timer again but to a universal one with no jumper. Would this be okay and what does that jumper do and do I need it for this refrigerator or not. Thank you
1 Answer Hello Tizzle, This is more likely to be a defective defrost thermostat. The job of the defrost thermostat is to open the circuit to the defrost heater when before the items in the freezer are melted, (normally about 50°F). The defrost timer will just cycle the defrost circuit in and out for a specified period of time. The defrost timer matters as long as it is for the same defrost intervals and defrost times. Read More...
Walt August 17, 2014 for Model Number 106 55244400 Have timer # 482493 were does the black wire go, no tech sheet.
1 Answer Walt, Based on your model number, the black lead wire would slide down over the terminal labeled 1 on the timer. Read More...
Robert S August 07, 2014 for Model Number TT14DKXSQ00 For this defrost timer, what position should the black wire be on? Is it terminal # 2? Also, if the black wire is placed on the wrong terminal, will this prevent the defroster from coming on? Would it cause a short that damages the defrost timer? Thanks.
1 Answer Robert, The black wire will go over the terminal labeled number 2. The timer will not be damaged by putting on a different terminal it will just not operate properly. Read More...
Luis R. August 05, 2014 for Model Number Daewoo FRG2120BRB Hi, I'm really having difficulty finding the defrost timer for my daewoo the part number on the timer is blank so I have no clue what timer I need please help.
Gary July 31, 2014 for Model Number ED25DQXDW05 Which terminal is the extra (black?) wire connected to for the correct defrost operation of this refridgerator?
1 Answer Gary, The black wire that comes off the motor of the timer will go to the terminal labeled number 2 for your unit. Read More...
Alexis V. July 10, 2014 for Model Number ED22DWXTWOO I Have Purchase a Defrost Timer from you all Part No. AP 3110896 and replaced the old Timer. Had 2 black wires and Metal cover and has a stud for a ground wire. I installed the Timer which had only one black wire, I placed it on terminal 2, and then into the Hones. Start up the Refrigerator but it is not cooling properly.
1 Answer Alexis, You have installed the correct defrost timer W10822278, and you have wired it correctly ( Terminal 1 - Black wire, terminal 2- pink wire and timer motor black lead wire, terminal 3 red wire and terminal 4 orange wire). What was the original problem that caused you to change the defrost timer ? and recheck or reset the settings on the control panel to the mid range settings, and allow the refrigerator to operate for 24 hours, before you readjust anything. Read More...
Garty July 02, 2014 for Model Number Whirlpool Refridgerator # ED25DDXDW05 Given this reference part AP3110896 as a replacement part for my defrost timer. When I check the reference on the page it says sorry this is not the right part for you model?
1 Answer Hello Garty! The correct defrost timer for this model number is part number W10822278. Thanks! Read More...