Customer Questions and Answers for Refrigerator Defrost Timer by Whirlpool

Woody, If the timer harness Has a white wire use terminal #1 If the timer harness does not have a white wire use terminal #2

Terry, The black wire on the timer will go to terminal number 1 on the timer.

Rami, the black wire would go onto terminal 2 for the model number provided.

Patrick, The black lead wire on the timer will go to terminal number 1.

Boiler, For your model, the black wire would attach to the #1 terminal.

Hello Paul, the manufacturer has discontinued adding the part Instruction Sheet for this part, however for your model place the jumper wire onto Terminal #2 and install the defrost timer.

Son, The black lead wire will need to be put on terminal number 1 of the timer.

Hello Linda, there is no wiring schematic available on this model from the manufacturer, however using this defrost timer the jumper wire goes on terminal 1 if one of the wires to the timer is white, if no white wire then the jumper wire goes on terminal 2.

Theguvna, a defrost timer would cycle based off of compressor run time and would not be set to a specific time separately from what has already been set during manufacturing. If the model number of your appliance could be provided in a new question, this may allow for more accurate information to be presented.

Mike if your defrost timer has these wires: Black, Pink, Red, & Orange Then the timer motor lead would go over the #2 terminal. if it has Orange, Pink, White, & Red then the timer motor lead would go over the #1 terminal.