Skip to Content
  • Same-Day Shipping Same-Day Shipping
  • 365 Day Return Policy! 365 Day Return Policy!
  • Trusted Since 1999 Trusted Since 1999
  • 5,000+ Repair Videos 5,000+ Repair Videos
  • Repair ForumFree Tech Support!
  • Top Quality Store on Google

Customer Questions and Answers for Smart Electronic Valve by Whirlpool

Best Seller
Manufacturer Part
4.89 (64)
By: Whirlpool
Part Number: OEM18065058
Manufacturer Part Number: WPW10455331

This smart electronic valve regulates on/off flow inside the appliance under command of the control system, helping the unit fill, dispense, or operate as designed. A precise, electronically driven valve is critical for consistent performance.

  • Opens and closes when energized to start or stop flow to the connected system
  • Coordinates with the control board for timed, accurate operation
  • Helps prevent overfill or underfill conditions
  • Common symptoms of a failing valve: no fill/flow, slow or intermittent flow, continuous flow when off, leaks from the valve body, or related fill/flow error codes
What's included: 1 smart electronic valve Install notes:
  • Disconnect power and shut off the appliance's supply line upstream before servicing
  • Keep towels or a container handy to catch residual fluid when lines are disconnected
  • Transfer connectors and any reusable brackets from the old valve to the new one, matching orientation
  • After installation, restore supply and power, then check all connections for leaks and proper operation

More
$186.95

IN STOCK
Ships Tomorrow Guaranteed
Add to Cart

Questions & Answers

For Whirlpool Smart Electronic Valve (Part Number: OEM18065058)

Rodrigo for Model Number WRF989SDAF00

My refrigerator is making ice randomly and ice collector pan is getting some water from ice maker. The water is leaking through the french doors down to freezer and get a small puddle of water at floor on the side of the ice maker. I read that it could be the water inlet valve not controlling and over-filling. What do you suggest to replace? W10455331 or W10341329? Or the ice maker unit? I pulled the valve the other day, checked water pressure and re-installed and started making ice on more frequent basis but still leaking water. I noticed on the back where the screws go in to secure the cardboard cover that water is leaking also through the bolt holes.

1 Answer

Rodrigo, Thanks for the question!!! Hard to say, need to troubleshoot. Here is a video link that may help: https://youtu.be/WobXQtBkwrw

Read More...
Gabe F for Model Number WRF989SDAF00

Two days ago dispenser stopped dispensing water and ice. Also appears that ice-making has stopped. Control/display panel still works. Attempting to dispense water results in no action and no noises heard. Attempting to dispense ice results in trap door opening, but nothing else happens and no other noises heard. Verified door switch not the issue by holding door open, holding door switch closed, seeing light go out, and same symptoms described earlier still occur. Pulled W10455331 (item 18 on Cabinet Parts Diagram) off the back. Verified sufficient water pressure at inlet (60 psig). Measured resistance of coil at 261.3 ohm. What are the chances that W10341329 (item 5 on Refrigerator Liner Parts diagram) has failed? What else can I try before disassembling the whole durn thing to get to the dual water valve? I have done this twice before for another issue and don't look forward to do it again. Thanks in advance! Your website is quite helpful!

1 Answer

Gabe,

For this issue the most likely cause will be a dispenser control board that is faulty. The part number for the control is W10861908.

Read More...

1 Answer

Nick, You do want to check the valves on the back of the refrigerator. Since neither the dispenser or the ice maker work, it's most likely the "isolation" valve WPW10455331. This valve supplies water to the filter and the ice maker, then the "dual" valve WPW10341329 dispenses water to the ice maker or the water dispenser. Both parts are in stock and available at this time. Thanks

Read More...

1 Answer

Hello Mike. Make sure the freezer is between 0° and 5°. You need to check and see if there is power going to the water valve when the icemaker cycles. If so, replace the water valve on the unit. If not, or the icemaker does not cycle, you will need to replace the icemaker on the unit. Also, check and make sure the fill tube on the unit is not frozen and clogged. If so, replace the water valve and thaw out the fill tube. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html

Read More...

Have questions? Ask our pros!

Contact us in a way that is convenient for you

Call us 1-877-477-7278
Need Help? Chat with a Pro
Or ask a question by filling in the form

Share your thoughts with other customers

Ask a Question
  • 5,000+ Repair Videos 5,000+ Repair Videos
  • Same-Day Shipping Same-Day Shipping
  • 365 Day Return Policy! 365 Day Return Policy!
  • Repair ForumFree Tech Support!
  • Top Quality Store on Google