Adela October 29, 2019 for Model Number Kenmore 11027132411 My washer is getting too much water in it. I ran the service diagnostics, and it did not return any errors. The pressure hose appears to be clear. The valve test did test higher than the recommended range of ohms. I'm not sure if I need to replace the valve assembly or if it's actually the pressure sensor that is bad. The washer does not overflow, but it just keeps filling, sensing, and filling until it's too full, and then it has trouble agitating, etc.
1 Answer Hello Adela,it sounds like the water level sensor that is mounted on the main control board is trying to fill the tub to what it thinks is the proper water level, it is dependent on air pressure building up in the airdrome on the outer tub and up thru the airline hose to the pressure switch. Replace the airline tubing first. it is part WP353244, any tiny air leak in the tubing or its end fittings will cause this problem. Read More...
Victor October 29, 2018 for Model Number W10758829 I need to replace the water inlet valve for a Whirpool Cabrio Top loader (WTW7000DW0). Does the water valve comes with the hire harness included?
1 Answer Victor, the inlet valve [W11220230] does not come with the wire harness, it will need to be purchased seperately. Read More...
Terry May 06, 2018 for Model Number WTW8000DW0 When my washer is off and unplugged it fills up with hot water. Please tell me there is a cheap fix for this. lol Have a wonderful blessed day and thank you.
1 Answer Terry, This issue will most likely be caused by a faulty water valve which is part number W11220230. Read More...
1 Answer Hello Ed, If voltage is being supplied to the water valve W11220230, it has failed and will require replacement. If no voltage is getting to the water valve when the unit should be filling, you will need to check the pressure switch/control W11723354. Read More...