Skip to Content
  • Same-Day Shipping Same-Day Shipping
  • 365 Day Return Policy! 365 Day Return Policy!
  • Trusted Since 1999 Trusted Since 1999
  • 5,000+ Repair Videos 5,000+ Repair Videos
  • Repair ForumFree Tech Support!
  • Top Quality Store on Google

Customer Questions and Answers for Dishwasher Vent Assembly by Whirlpool

Best Seller
Manufacturer Part
4.89 (64)
By: Whirlpool
Part Number: OEM18065847
Manufacturer Part Number: WPW10469574

Steam escaping from door or dishes not drying? The vent assembly expels heat and moisture during cycles. Moderate DIY repair, takes about 15 minutes.

More
$67.95

IN STOCK
Ships Today Guaranteed
Add to Cart

Questions & Answers

For Whirlpool Dishwasher Vent Assembly (Part Number: OEM18065847)

1 Answer

Hello Walt, and thank you for your question. If there is not a damaged wire, and the vent fan turns on, the main control W10866116 would be the likely cause of failure.

Read More...

1 Answer

Ron,
If the vent assembly did not solve the issue (make sure the vent is functioning) you might check the door gasket to make sure it is sealing properly as well.

Read More...

1 Answer

Jim,

This issue would most likely be caused by a relay in the control board that is stuck keeping the fan on continuously.The control board would need to be replaced for this issue.

Read More...

1 Answer

John, It most likely is condensation, Check to make sure the water isn't too hot. Check the upper spray arm/nozzle to make sure it moves properly and isn't spraying the water towards
the vent cover at the top of the inner door panel,and the detergent and rinse aid isn't "foaming" up. If you remove the lower kick plate panel, you should find the tech data sheet attached to the back of the panel. You can review any error codes logged by the eeprom, and can operate all the components of the dishwasher.

Read More...
Bad Karma for Model Number Kenmore Elite 12783

We've been experiencing problems for a year with this vent part. It has been replaced once by Sears. It has failed again, allowing steam to exit the side of the door and ruin the adjacent cabinet. It seems either the damper is malfunctioning, the fan, or both. Can you tell me the purpose of the gap in the assembly by the fan? Does the fan create enough pressure to keep the steam from entering the door panel cavity? I've already replaced my circuit panel as I think the steam was damaging it. Does this include the o-ring gasket?

1 Answer

Hello Michael. The best way is to watch it during the drying cycle and see if it does. If not, then you will need to replace the control board. You also need to check all the seals. One may be bad and allowing steam into the door.

Read More...

Have questions? Ask our pros!

Contact us in a way that is convenient for you

Call us 1-877-477-7278
Need Help? Chat with a Pro
Or ask a question by filling in the form

Share your thoughts with other customers

Ask a Question
  • 5,000+ Repair Videos 5,000+ Repair Videos
  • Same-Day Shipping Same-Day Shipping
  • 365 Day Return Policy! 365 Day Return Policy!
  • Repair ForumFree Tech Support!
  • Top Quality Store on Google