Jon April 19, 2012 for Model Number LSE7806ACE Hello, My washer won't fill with water and I suspect the pressure switch. Is there any way to test it .I have a digital ohm meter.
1 Answer Hello Jon. Set the load level to large on the pressure switch 12002304. Then test across pins 1 and 3. Should read closed when empty and pins 1 and 2 should be open. Then fill the unit up and once full, pin 1 and 2 should read closed and 1 and 3 should be open. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. Hope this helps. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html Read More...
Jan January 02, 2012 for Model Number LSE7804ACE Can faulty water switch trip a circuit breaker? I have noticed that in my washer. I am not sure if this water switch can cause this. I've checked electric motor and it looks fine. Please advise what part cause the breaker tripping. Thanks, JH
1 Answer Hello Jan. Yes, if the water level switch 12002304 is shorted to ground, it can trip the breaker. Most likely it is the motor causing the problems with the unit. Hope this helps. Read More...
Andrea December 12, 2011 for Model Number lse7806ace My washer won't fill with water. I replaced the water inlet valve and still no water in tank. What do you suggest? Thank you P.S. It does spin.
1 Answer Hello Andrea. Based on the information you provided, if the water comes from the hoses good, and the valve is new, it sounds like the pressure switch 12002304 is bad and will need to be replaced. Hope this helps. Read More...
1 Answer Hello Renwick. Check and make sure the pressure hose is good and is not clogged. If the washer overflows and you can shut it off with the on and off switch, you will need to replace the pressure switch 12002304. If you have to turn the water off, you will need to replace the water valve. Hope this helps. Read More...