Parts for Ge ZISS360DKBSS: Quick Chill Parts

Replace your refrigerator water filter every 6 months to maintain clean water and ice. Removes contaminants for fresh taste. Easy DIY install in minutes.

This quick chill pan assembly helps direct cold from the evaporator to the freezer compartment so items chill faster and maintain even temperatures. Designed as a direct-replacement evaporator pan for compatible freezers. What it does

• Moves cold from the evaporator area into the freezer to improve cooling consistency.
• Helps reduce warm spots on the freezer floor so stored items chill more evenly.
• Supports proper drainage and defrost flow in models that use a dedicated chill pan.
• Commonly replaced when the freezer is slow to cool or the interior shows uneven temperatures.

• Disconnect power to the appliance before beginning any repairs.
• Refer to the OEM service manual for model-specific removal and reassembly steps; some disassembly of the evaporator cover is usually required.
• Avoid bending or contacting evaporator fins and tubing; do not attempt sealed-system repairs.

Fix fresh food section freezing or not cooling issues with this air damper assembly. Controls airflow between freezer and refrigerator compartments.

This Cover QC is the protective control cover that shields the appliance's quick-connect terminal area and control components, helping keep wiring secure and components safe from accidental contact or debris. What it does:

• Protects control terminals and wiring from damage, dust, and accidental contact
• Maintains a tidy, finished appearance around the control area
• Helps prevent intermittent electrical connections caused by exposed terminals
• Commonly replaced when cracked, broken, missing, or preventing proper connector fit

• Disconnect power to the appliance before beginning any service
• Remove access panels or bezels as needed to reach the control area
• Handle connectors gently and avoid forcing or bending terminals during reinstallation

Replace a cracked or broken quick connect housing assembly in your side-by-side refrigerator. Includes mounting hardware for secure installation.

This thaw heater is the evaporator defrost heating element that melts frost during the refrigerator's defrost cycle. Replacing a failed heater helps restore normal defrosting and reduce frost buildup that can restrict cooling. What it does:

• Heats the evaporator coil during the defrost cycle to melt accumulated ice
• Prevents excessive frost buildup that can block airflow and reduce cooling efficiency
• Common symptoms of a failing heater: heavy frost or ice on the evaporator/back wall, reduced cooling, or long compressor run times
• Works as part of the appliance's defrost system alongside the defrost thermostat and control

• Disconnect power to the appliance before starting any repair
• Access typically requires removing interior panels and the evaporator cover; handle the evaporator and wiring carefully
• Inspect associated defrost components (thermostat, timer/control) if problems persist; replace only parts confirmed faulty

This cover protects and tidies the refrigerator water line area, keeping hoses routed and partially shielded for a cleaner look and reduced snag risk. It's a simple trim piece used where water lines exit or run along the cabinet. What it does

• Conceals and organizes exposed refrigerator water lines for a neater appearance
• Helps prevent hoses from catching or rubbing against other components
• Restores missing or damaged trim that leaves water lines exposed
• Works with factory routing to maintain intended hose positioning

• One water line cover/trim piece

• Disconnect power and shut off the water supply before starting work
• Access may require moving the refrigerator away from the wall or removing a rear/top trim panel
• Typically secures with clips or screws—retain hardware from the original part if possible

Fix ice buildup on evaporator coils with this defrost thermostat. Monitors coil temperature to signal defrost cycles. Test for continuity when frozen.