Parts for Bosch DAH9466UC: Range Hood Assembly Parts

The Lamp Holder is an OEM part for Bosch range hoods. It secures interior lighting fixtures in place above the stovetop, managing connecting wires neatly out of the way. Proper holder positioning ensures consistent task illumination.

Causes of failure can include normal wear from sustained vibration in the kitchen environment. Periodic replacement preserves essential visibility above the cooktop.

Symptoms of a faulty lamp holder are:

• Interior hood light failing to illuminate or flickering inconsistently
• Visible damage or deterioration of mounting clips/anchors
• Loosening of lighting unit from repeated cleaning

This genuine OEM Bosch part is also compatible with Thermador, Gaggenau and select Kenmore models.

This metric M4 x 8 screw secures the toe-kick/lower access panel at the base of the appliance. Replace a missing or stripped fastener to keep the kickplate tight and aligned, helping prevent looseness and noise.

• Secures the toe-kick or lower access panel to the base/frame
• Restores proper fit when the original screw is lost or damaged
• Helps reduce panel rattles and vibration
• Maintains correct alignment and clearance at the bottom edge

• Disconnect power before servicing; also shut off the water supply
• Support the panel and align holes before threading the screw
• Start by hand to avoid cross-threading; tighten snugly—do not overtighten
• Verify size matches the original; replace matching hardware together if required by your model

This cable harness routes power and control signals between the appliance control and internal components so systems receive reliable electrical connections for normal operation. It replaces damaged or worn wiring to restore proper circuit continuity and function. What it does:

• Connects the control board to motors, sensors, valves, and other internal components
• Restores missing or intermittent electrical connections caused by frayed, burned, or broken wires
• Helps stop symptoms like no power to components, intermittent operation, or control errors
• Provides factory-style connector fit and correct wiring routing when installed

• Always disconnect electrical power before starting any repair
• Match connector shapes and wire colors; route harness along original clips and fasteners
• Inspect mating connectors and terminals for corrosion or damage; replace if needed