Parts for Ge JV347X1BB: 01 - Range Hood Parts

The Grease Filter is an OEM part for GE range hoods. It is designed to trap grease and other particles from the air that circulates through your cooking appliances, preventing buildup within the ventilation system. 

Causes of a bad Grease Filter can include saturation from accumulated grease and debris, which can limit its effectiveness and airflow. Over time, the filter can also become damaged or corroded, reducing its ability to capture and hold grease particles.

Symptoms of a bad Grease Filter include:

• Visible grease buildup on the filter surface.
• Reduced effectiveness in venting smoke or cooking odors.
• Increased smoke and odors lingering in the kitchen during and after cooking.

This GE replacement part is also compatible with Hotpoint, RCA, and some Kenmore models.

The Charcoal Filter is an OEM part for GE microwaves. It is designed to remove odors and impurities from the air that is recirculated during microwave operation. The charcoal filter plays a crucial role in maintaining a clean and odor-free kitchen environment by trapping grease and odors from the cooking process.

You should replace the charcoal filter regularly as part of routine maintenance. Causes of a bad charcoal filter can include saturation from grease and food particles, reduced effectiveness due to prolonged use, or physical damage.

Symptoms of a bad charcoal filter include:

• Persistent odors in the kitchen
• Visible grease buildup on the filter
• Reduced ventilation efficiency

This GE replacement part is also compatible with Hotpoint, RCA, and some Kenmore models.

This small plastic wire clip secures an appliance wiring harness to the cabinet or chassis, keeping wiring routed and held firmly to prevent rubbing or pinching during use. What it does:

• Holds wiring harnesses in place to reduce movement and protect insulation
• Prevents wires from contacting hot or sharp surfaces that can cause wear
• Reduces rattling or banging noises from loose wiring
• Helps prevent intermittent electrical connections caused by loose or strained wires

• One wire clip

• Disconnect power to the appliance before starting any work
• Clip typically snaps into a pre-punched hole or slides onto a flange; line up the harness and press clip until it seats
• Inspect wiring and insulation when replacing clip; route wires away from heat and moving parts
• Replace with the exact part number for a proper fit