Parts for Frigidaire 2819A: Range Page 9 Parts

This part has been discontinued by the manufacturer and is no longer available.

This trim wrapper is the outer decorative trim piece that finishes the appliance opening and protects internal edges for a clean, finished look. It restores appearance and helps keep seals and components covered. What it does:

• Covers and protects the exposed edge of the appliance opening for a finished appearance
• Helps keep surrounding seals and components shielded from spills and debris
• Replaces cracked, bent, or cosmetically damaged trim that affects appearance
• Restores the proper fit and alignment of adjacent panels when the trim is the cause of gaps

• Trim - wrapper

• Disconnect power or unplug the appliance before starting any repair
• Remove adjacent panels or fasteners as needed; retain all screws and clips for reassembly
• Handle edges carefully—trim pieces and mounting points can be sharp
• Compare mounting tabs and screw locations to the original part before final installation

This part has been discontinued by the manufacturer and is no longer available.

This control knob replaces a worn, damaged or missing range/oven control knob so you can select heat settings easily and safely. It restores a solid grip and reliable control over stove or oven functions. What it does:

• Fits onto the control shaft to turn temperature or function settings
• Replaces cracked, loose or stripped knobs that are hard to turn
• Helps prevent accidental setting changes from a damaged knob
• Restores proper tactile feedback for precise adjustments

• Turn appliance controls off and disconnect power before replacing the knob
• Pull the old knob straight off the control shaft and push the new knob on until fully seated
• If the knob is hard to remove, use a cloth and gentle leverage; do not force or pry on surrounding trim
• Inspect the control shaft for damage; replace shaft or control if the knob does not seat securely

This right-side end cap is a replacement trim piece that secures and finishes the outer edge of the appliance door/frame, restoring appearance and helping keep the door components aligned for smooth operation. What it does:

• Covers and protects the outer edge of the door/frame and internal components from dirt and damage
• Holds adjacent trim and seals in proper position to reduce gaps and rubbing
• Restores factory appearance where a cracked or missing end cap left an exposed edge
• Helps prevent minor snagging when opening or closing the door

• Disconnect power to the appliance before starting any repair
• Removal/installation typically requires light prying or removing a few trim screws; use non-marring tools to avoid damage
• Align tabs or slots and press/secure the cap until it snaps into place; verify even fit along the edge
• If sealing or alignment issues persist after installation, check adjacent trim and fasteners for wear or damage