Parts for Frigidaire 2879A: Range Parts

This part has been discontinued by the manufacturer and is no longer available.

This trim wrapper is the outer decorative trim piece that finishes the appliance opening and protects internal edges for a clean, finished look. It restores appearance and helps keep seals and components covered. What it does:

• Covers and protects the exposed edge of the appliance opening for a finished appearance
• Helps keep surrounding seals and components shielded from spills and debris
• Replaces cracked, bent, or cosmetically damaged trim that affects appearance
• Restores the proper fit and alignment of adjacent panels when the trim is the cause of gaps

• Trim - wrapper

• Disconnect power or unplug the appliance before starting any repair
• Remove adjacent panels or fasteners as needed; retain all screws and clips for reassembly
• Handle edges carefully—trim pieces and mounting points can be sharp
• Compare mounting tabs and screw locations to the original part before final installation

This part has been discontinued by the manufacturer and is no longer available.

Replaces a worn, cracked, or missing range control knob. Fits onto the control shaft to adjust temperature and function settings on your stovetop.

Decorative nut for gas range exterior trim. Secures cosmetic panels and trim pieces. Replace if lost, stripped, or corroded for a clean finish.

This right-side end cap is a replacement trim piece that secures and finishes the outer edge of the appliance door/frame, restoring appearance and helping keep the door components aligned for smooth operation. What it does:

• Covers and protects the outer edge of the door/frame and internal components from dirt and damage
• Holds adjacent trim and seals in proper position to reduce gaps and rubbing
• Restores factory appearance where a cracked or missing end cap left an exposed edge
• Helps prevent minor snagging when opening or closing the door

• Disconnect power to the appliance before starting any repair
• Removal/installation typically requires light prying or removing a few trim screws; use non-marring tools to avoid damage
• Align tabs or slots and press/secure the cap until it snaps into place; verify even fit along the edge
• If sealing or alignment issues persist after installation, check adjacent trim and fasteners for wear or damage