Parts for Electrolux GL30LBEC: 03 - Recommended Spare Parts

This gauge displays temperature readings for monitoring appliance operating conditions. It provides visual feedback on internal temperatures to help ensure proper operation and food safety. Replace it if the gauge shows incorrect readings, the needle is stuck, or the display is cracked or unreadable.

Grill flavor grid that sits above the burner to distribute heat and protect components. Replace if cracked, warped, rusted, or missing for proper cooking.

If your grill burner won't light or sparks weakly, this electrode spark igniter creates the spark needed for reliable gas ignition. Simple DIY fix.

This replacement control knob restores safe, accurate selection of oven or range settings and replaces a cracked, worn, or stripped control knob for a reliable grip and clear pointer feedback. Easy push-on replacement for normal wear. What it does:

• Fits over the appliance control shaft to set oven or burner temperature and mode
• Replaces knobs that are cracked, faded, loose, or no longer grips the control shaft
• Restores clear pointer alignment so settings are visible and selectable
• Simple mechanical part — no wiring or electronics involved

• One control knob

• Disconnect power to the appliance or turn controls off before replacing
• Typically installs by pulling the old knob straight off and pushing the new knob onto the splined shaft
• Align pointer with the desired setting before full seating; do not force or hammer
• If the knob will not seat, inspect shaft and retaining clip for damage and replace damaged parts as needed

Control knob for grill burner valve operation. Installs on the front control panel. Replace if cracked, broken, loose, or missing for proper valve control.

This replacement handle end is the small end cap that finishes and secures a refrigerator or freezer door handle for a clean, finished look. It restores a snug fit and hides the handle fastener. What it does:

• Covers and protects the exposed handle fastener or mounting area
• Helps keep the handle snug and prevents wobbling or rotation
• Restores finished appearance to a cracked, chipped, or missing end piece
• Useful when the original end cap is broken, lost, or cosmetically worn

• One handle end (end cap) as pictured

• Usually secures by snapping or sliding onto the handle; may require removing handle or a single screw
• Use basic hand tools; keep screws and brackets for reassembly
• No electrical disconnection required for door-handle end cap replacement

This is the left-side end cap that attaches to the end of the oven door or drawer handle. It provides a finished appearance and protects the handle mounting hardware. Replace this end cap if it is cracked, broken, or missing, which can leave the handle feeling loose or expose sharp edges.

If your grill burner won't light or has delayed ignition, this electrode creates the spark needed to ignite gas. Simple DIY fix restores reliable lighting.

This bolt secures the gas valve or manifold assembly to the range body. It ensures a tight, stable connection that is critical for safe gas flow and burner operation. Replace this bolt if it is stripped, corroded, or missing, which can result in a loose valve or manifold and potential gas leaks.

Replacement mounting screw for grill assembly. Secures components and panels in place. Order a new screw if original is stripped, missing, or damaged.

This is an insulated wire lead that connects the igniter to the infrared broil burner at the bottom of the oven. It carries the electrical signal needed to ignite the burner element. Replace this wire if the infrared burner fails to ignite, if the insulation is cracked or burned, or if you notice intermittent ignition problems.