Parts for Electrolux RH36PC60GSB: 03 - Recommended Spare Parts

Mounting angle bracket for range hoods. Secures hood to wall or cabinet during installation. Replace if bent, cracked, or missing for proper support.

Mounting channel for range hood installation. Provides structural support for securing the hood to your cabinet or wall. Replace if bent, damaged, or missing.

Fix no display, won't start, or intermittent power issues in your hood. This control board regulates voltage to restore reliable operation and startup.

This blower assembly circulates air through the appliance to support proper airflow and heat distribution, restoring normal operation and efficiency when the original blower is damaged or failing. It replaces worn or broken blower components to reduce noise and improve performance. What it does:

• Spins the blower wheel to move air through the unit for proper heating, cooling, or venting
• Restores airflow when reduced air movement causes longer cycles or poor performance
• Reduces unusual noise from a wobbling or damaged blower wheel/housing
• Helps prevent overheating caused by restricted or ineffective air circulation

• Disconnect power (and gas if applicable) before starting any repair
• Access typically requires removing exterior panels or the front panel; use basic hand tools
• Inspect and clean surrounding airflow paths and vents of lint or debris while replacing the blower

This metal mounting angle brackets a component to the appliance frame, restoring proper alignment and stable support for the attached assembly. It's a simple replacement that helps stop shifting, rubbing, or loose fits. What it does:

• Provides a secure mounting point for an appliance sub-assembly to the cabinet or frame
• Restores correct alignment to doors, panels, or internal components that rely on the bracket
• Stops movement, rattling, or rubbing caused by a bent or broken angle bracket
• Durable metal construction designed for OEM fit and function

• One angle as shown

• High-level replacement: remove any obstructing trim or components, unfasten the old bracket, and secure the new bracket with the original screws
• Verify alignment before fully tightening fasteners; adjust as needed for correct fit
• Use appropriate hand tools; avoid overtightening fasteners which can strip mounting holes
• Disconnect power when working near electrical components

Front console touch pad that houses control buttons and display for your range hood. Replace if cracked, broken, non-responsive, or display is damaged.

This is a mesh grease filter that fits inside a range vent hood to capture grease and airborne particles produced during cooking. It helps keep the exhaust system clean and prevents grease buildup in the ductwork. Replace this filter if it appears heavily discolored, clogged with grease, or no longer effectively traps cooking vapors.

Hood lamp assembly provides lighting over your cooking area. Replace when light fails despite new bulb or socket shows damage. Verify fit with your model number.

Installation kit for range hoods. Includes mounting hardware and components needed to properly secure your hood. Replace missing or damaged brackets and screws.

This is a charcoal filter designed for a range vent hood that recirculates air rather than venting it outside. The activated charcoal absorbs cooking odors, smoke, and grease particles from the air drawn through the hood. Replace this filter if you notice persistent cooking odors lingering in the kitchen or reduced effectiveness of your hood's ventilation.