Parts for Lg 51822: Refrigerator Compartment Parts

Replace your refrigerator's shelf assembly when cracked, broken, or worn. This shelf installs inside the fresh food compartment to organize and support food.

Replacement vegetable crisper drawer assembly for side-by-side refrigerators. Replaces cracked, broken, or missing drawers in the fresh food compartment.

Fix poor cooling or excess frost buildup with this insulated duct assembly. Restores airflow between compartments. Moderate DIY repair, 30-45 minutes.

Replace your refrigerator's light cover assembly if cracked, yellowed, or missing. Protects the interior bulb and diffuses light. Verify fit with model number.

This replacement sensor cover protects the washer lid sensor assembly and helps keep the sensor aligned for proper operation. It restores the sensor housing so lid-detect functions work reliably. What it does:

• Shields and secures the lid sensor assembly from moisture, lint, and physical damage.
• Helps maintain correct sensor alignment so the washer can detect lid position.
• Commonly replaced when the original cover is cracked, broken, or missing.
• Resolves symptoms like lid-not-detected errors or intermittent lid-related cycle interruptions.

• Disconnect the appliance power before beginning any repair.
• Handle the cover and sensor gently to avoid damaging the sensor or wiring.
• Follow the appliance service manual for correct removal and reassembly procedures.

Replace your cracked, warped, or broken refrigerator crisper drawer tray. Restores proper fresh food storage in the lower produce compartment.

Replacement fastener nut for refrigerators. Secures internal components, brackets, and panels. Replace when missing, stripped, or loose to prevent vibration.

If your refrigerator display is dead, shows error codes, or behaves unpredictably, this sub PCB assembly processes inputs and controls specific functions.

This leveling leg assembly stabilizes and levels your refrigerator so it sits solidly on the floor and the doors align correctly. Replacing a worn or stripped leg helps reduce rocking and vibration and restores smooth leveling adjustment.

• Provides height adjustment to level the cabinet on uneven floors
• Supports the unit to prevent rocking or wobbling
• Helps doors close and seal properly when the cabinet is level
• Symptoms may include persistent wobble, vibration/rattling, or a stripped/bent foot or screw

• Unplug the refrigerator and use a helper to prevent tipping injuries.
• Protect flooring; remove the kickplate/grille for access if present.
• Thread out the worn leg; hand-thread the new assembly and adjust height—do not over-extend.
• Level side-to-side and front-to-back per your owner's manual, then reattach any panels.

This hinge lever mounts on the refrigerator door hinge to guide door movement and closure, helping the door seal properly. Replacing a worn or broken lever restores smooth operation and consistent sealing.

• Guides hinge motion so the door opens and closes smoothly
• Helps maintain door alignment for a reliable gasket seal
• Replace if the lever is visibly cracked, worn, or deformed

• Disconnect power and support the door to prevent injury or damage
• Remove the hinge cover and fasteners; note the lever's orientation before removal
• Install the new lever in the same position and reassemble the hinge components
• Adjust hinge per model procedures if needed

Removes contaminants for clean, fresh-tasting water and ice. Replace every 6 months or 200 gallons to maintain water quality. Verify fit with your model.

Lower hinge assembly supports and aligns your refrigerator door. Replace if cracked, broken, or worn causing misalignment or door sag. Installs at door bottom.