Parts for Whirlpool EB2SHKXVD02: 05 - Refrigerator Door Parts

Outer door panel for your refrigerator. Replaces the exterior shell of your fridge door when cracked, dented, scratched, or discolored.

Replacement mounting screw for securing panels, brackets, and components inside your appliance. Needed when original screws are stripped, lost, or damaged.

Medium door bin for refrigerator fresh food compartment. Replaces cracked, broken, or missing door shelf. Snaps into door rails for secure storage.

Refrigerator door gasket seals the fresh food compartment to maintain temperature. Replace if torn, cracked, or causing moisture buildup. Verify fit.

Seals the fresh food compartment door to maintain proper temperature and prevent air leaks. Replace if torn, cracked, or not sealing properly. Confirm fit.

Black refrigerator door handle installs on the exterior door for opening and closing. Replace if cracked, broken, loose, or missing grip hardware.

This replacement screw secures panels, brackets, and components inside appliances. Replacing a missing or stripped fastener restores a snug, rattle-free fit using the correct #8-18 thread and 5/8-inch length.

• Fastens covers, trims, brackets, and internal parts to the cabinet/frame
• Used wherever a #8-18 x 5/8 screw is specified
• Replace if the original is missing, corroded, stripped, or will not tighten
• Symptoms: loose or rattling panels, gaps, or hardware that backs out

• Disconnect power; shut off gas/water before servicing
• Match thread and length; start by hand to avoid cross-threading
• Use the correct driver bit and tighten snugly—do not overtighten
• Inspect and replace damaged clips or tabs before securing

White door stop that limits how far your refrigerator door swings open. Replace if broken, cracked, or missing to prevent door overextension and damage.

Refrigerator name plate attaches to the exterior cabinet to display model information. Replace if plate is faded, cracked, peeling, or missing.

Plastic retainer bar that securely holds door shelves in place inside your refrigerator. Replace if cracked, broken, or worn from regular use.

White plastic bushing that sleeves the hinge pin where your refrigerator door pivots. Replace when cracked, worn, or missing to restore smooth door swing.

This door bushing fits on the refrigerator hinge/closer to provide a smooth pivot point and proper door alignment. Replacing a worn bushing reduces squeaks and binding and helps the door close and seal as designed.

• Provides a low-friction bearing surface between the hinge pin/closer cam and the door
• Helps maintain correct door height and alignment to the cabinet
• Promotes smooth door swing and reliable self-closing action
• Typical wear symptoms: squeaking or grinding, binding, door sag, or poor sealing

• Disconnect power and support the door before removing hinge hardware
• Note the order/orientation of hinge parts and any shims; lift off the door carefully
• Install the new bushing on the hinge pin or in the door as shown in your model's diagram
• Reinstall, level, and verify the gasket seals evenly all around