Parts for PBFS21EDBP: Refrigerator Parts

This leveling leg and bracket assembly provides an adjustable support foot to stabilize and level the appliance for safe, even operation. Restores proper height and prevents rocking or uneven door alignment. What it does:

• Supports one corner of the appliance and lets you raise or lower height for a level installation
• Helps stop rocking, wobbling, or uneven operation caused by an out-of-level cabinet or floor
• Maintains proper clearance and alignment for doors and drawers to close smoothly
• Designed as a direct-fit replacement for the OEM leveling leg/bracket assembly

• Turn off power to the appliance and disconnect from power source if working near electrical components
• Block or support the appliance before removing or adjusting legs to prevent tipping; have a helper if needed
• Use basic hand tools to remove the old bracket and install the new assembly; tighten securely but avoid over-torquing

Water filter removes contaminants and turbidity from the water supply to improve quality. For optimal performance, filter should be replaced regularly. Quick, simple installation requires no special tools.

This condenser fan motor powers the refrigerator condenser fan to help move air across the condenser coils for proper cooling and efficient compressor operation. It replaces a failed fan motor so the condenser fan can run normally. What it does:

• Spins the condenser fan blade to pull or push air across condenser coils for heat dissipation.
• Restores proper airflow when the fan motor has seized, hums, or won't start.
• Helps reduce compressor cycling caused by poor condenser airflow.
• Works with the existing fan blade and mounting hardware when the motor is the only failed component.

• Disconnect power to the appliance before servicing to avoid electrical shock.
• Handle with care to avoid bending condenser fins or damaging wiring.

This articulating mullion with built-in heater is the vertical door trim assembly that seals and insulates the gap between double doors, helping prevent frost and condensation. It restores proper door alignment and improves cold-air sealing. What it does:

• Provides a hinged vertical seal between freezer/refrigerator doors to help doors close smoothly and stay aligned
• Built-in heater reduces ice build-up and condensation along the door gap
• Helps maintain proper cold-air containment for consistent interior temperature
• Commonly replaces parts causing visible frost, moisture between doors, or binding/uneven door closure

• One articulating mullion assembly with heater

• Always disconnect power to the appliance before beginning repair
• Handle trim and heater wiring gently; ensure electrical connectors are fully seated and routed clear of moving parts
• After installation, restore power and verify doors close evenly and heater operates (check for heat at mullion after a short run)