Parts for Electrolux E36PC75GSS: 03 - Replacement Parts

Replacement touch pad for your range hood control panel. Installs on the front interface. Order when your touch pad is cracked, unresponsive, or worn.

This replacement cover protects the control housing and internal components, restoring a finished appearance and helping keep wiring and switches shielded from debris. It's a direct-fit exterior trim piece for affected appliance models. What it does:

• Shields control board, wiring, and switches from dust, spills, and physical contact
• Restores the appliance's finished appearance when an original cover is cracked or missing
• Helps prevent rattles or vibration noise caused by a loose or damaged cover
• Allows control area to mount securely and align with surrounding trim

• Disconnect power to the appliance before starting any repair to avoid shock or injury
• Basic hand tools are typically required; remove any surrounding trim to access mounting clips or screws
• Align tabs/clips, press or fasten the cover fully into place without forcing; damaged clips may need replacement

Discharge collar for range hoods. Connects ductwork to the exhaust outlet. Replace if cracked, dented, or missing to ensure proper ventilation fit.

Replace your damaged or missing hood vent frame. This structural component secures ductwork and provides proper ventilation support for your range hood.

Exterior trim piece that secures and finishes the hood door opening. Replace if cracked, bent, or damaged to restore proper door alignment and appearance.

This hose clamp secures flexible hoses to fittings, helping prevent leaks and keep connections tight. It's a small replacement part that restores a secure seal where hoses attach to valves or pumps. What it does:

• Holds a hose firmly on a barb or spigot to prevent slipping or leaks
• Restores a tight connection at water or drain hose joints
• Commonly used where a loose hose causes visible leaking, pooling, or poor drainage
• Simple, low-profile design fits into tight appliance spaces

• Turn off power and shut off water supply before servicing
• Access the hose connection, slide the clamp into place, then tighten or pinch per clamp type
• Replace clamps showing corrosion, cracks, or loss of tension

A small replacement clamp that secures appliance hoses and lines to fittings, helping prevent leaks and loose connections. Fits where a compact, durable clamp is needed for reliable hose retention. What it does:

• Secures hoses or lines to fittings to reduce movement and help prevent leaks
• Stabilizes water or drain lines to stop rattling and hose wear
• Helps maintain a sealed connection at hose joints and barbs
• Commonly used on refrigerators and other household appliances for hose retention

• Disconnect power and shut off water supply before servicing appliances
• Use pliers or the appropriate clamp tool to remove and install the clamp safely
• Verify correct clamp position and tightness—do not overtighten to avoid damaging the hose

This bracket is a replacement mounting bracket that secures internal components so assemblies stay aligned and supported for reliable operation. It restores proper fit where a broken, bent or missing bracket causes loose or misaligned parts. What it does:

• Provides rigid support to hold panels, housings or internal assemblies in their correct position
• Prevents shifting, sagging or vibration that can cause noise or poor component alignment
• Restores secure attachment points after damage, wear or corrosion
• Helps maintain proper spacing so connected parts can operate correctly

• Disconnect power to the appliance before starting any repair
• Use basic hand tools; handle edges carefully to avoid cuts
• Verify bracket orientation and alignment with mating parts before tightening fasteners
• Replace with OEM-equivalent hardware if fasteners are damaged or missing.

Replacement housing cover for range hoods. Installs as the exterior shell or casing. Needed when original is cracked, dented, discolored, or damaged.