Parts for Frigidaire PL36WC40EC: 03 - Replacement Parts

This is a 20-watt halogen light bulb designed for use in range vent hoods. It provides task lighting over the cooktop to illuminate the cooking surface. Replace this bulb if the hood light has burned out, flickers, or no longer turns on.

This replacement cover protects the control housing and internal components, restoring a finished appearance and helping keep wiring and switches shielded from debris. It's a direct-fit exterior trim piece for affected appliance models. What it does:

• Shields control board, wiring, and switches from dust, spills, and physical contact
• Restores the appliance's finished appearance when an original cover is cracked or missing
• Helps prevent rattles or vibration noise caused by a loose or damaged cover
• Allows control area to mount securely and align with surrounding trim

• Disconnect power to the appliance before starting any repair to avoid shock or injury
• Basic hand tools are typically required; remove any surrounding trim to access mounting clips or screws
• Align tabs/clips, press or fasten the cover fully into place without forcing; damaged clips may need replacement

This is a small washer used in range hood assemblies to secure components and reduce vibration. It helps maintain a tight, stable fit between mounted parts. Replace this washer if it is cracked, deformed, or missing, which can lead to loose fittings or rattling noises during hood operation.

Replacement power cord for your range hood. Connects the hood to your electrical outlet. Order a new cord if yours is frayed, damaged, or missing.

Replace the decorative canopy trim on your range hood. This trim piece covers the mounting area and ductwork. Order a new one if yours is dented or damaged.

Discharge collar for range hoods. Connects ductwork to the exhaust outlet. Replace if cracked, dented, or missing to ensure proper ventilation fit.

This replacement door gasket provides a flexible, airtight seal for refrigerator doors to help maintain proper cooling and reduce moisture intrusion. Designed to restore door sealing performance and help prevent temperature loss. What it does:

• Seals the door perimeter to keep cold air in and warm air out
• Helps reduce frost build-up and interior moisture
• Can improve cooling consistency and energy efficiency when the original seal is worn
• Common symptom: visible gaps, torn or hardened gasket, or excessive condensation around the door

• One replacement door gasket

• Disconnect power to the appliance before attempting replacement
• Remove the old gasket and clean the mounting surface of debris and adhesive residue
• Align and press the new gasket into the door channel, working around corners for an even seal
• Check the seal after installation and allow the gasket to settle; adjust as needed for a snug fit

Chimney extension cover for range hoods. Extends the decorative ductwork to accommodate higher ceiling installations. Replace if damaged or missing.

This hose clamp secures flexible hoses to fittings, helping prevent leaks and keep connections tight. It's a small replacement part that restores a secure seal where hoses attach to valves or pumps. What it does:

• Holds a hose firmly on a barb or spigot to prevent slipping or leaks
• Restores a tight connection at water or drain hose joints
• Commonly used where a loose hose causes visible leaking, pooling, or poor drainage
• Simple, low-profile design fits into tight appliance spaces

• Turn off power and shut off water supply before servicing
• Access the hose connection, slide the clamp into place, then tighten or pinch per clamp type
• Replace clamps showing corrosion, cracks, or loss of tension

Fix a hood that won't power on or has no lights with this transformer. This essential electrical component converts voltage to power your range hood.

Replacement housing cover for range hoods. Installs as the exterior shell or casing. Needed when original is cracked, dented, discolored, or damaged.