Parts for Ge ASM14AKS1: 01 - Room Air Conditioner Parts

This nut-washer fastener secures appliance components where a combined nut and washer is required, helping hold parts tight and resist loosening from vibration. Use it when the original fastener is missing, damaged, or corroded. What it does:

• Secures panels, brackets, or assemblies by combining a nut and washer in one piece
• Helps prevent loosening from vibration or movement
• Restores proper clamping force when the original fastener has worn or failed
• Useful for quiet, rattle-free operation when mounting components

• Disconnect power to the appliance before servicing to avoid shock or injury
• Replace only with the exact part number or an exact-match fastener for proper fit
• Hand-start threads to avoid cross-threading, then tighten with appropriate tool
• Do not overtighten; snug until secure to avoid stripping threads or deforming parts

This evaporator blower fan blade circulates cold air through the refrigerator to maintain even cooling and proper frost control. Replacing a worn or broken blade restores airflow and helps the appliance cool more consistently. What it does:

• Spins on the evaporator motor to move air across the evaporator coils
• Promotes even temperature distribution inside the fresh-food and freezer compartments
• Helps prevent frost build-up by maintaining steady airflow
• Commonly replaced when airflow is weak, the fan is noisy, or the blade is cracked or broken

• One fan blade

• Disconnect power before accessing the evaporator/fan area to avoid shock or injury
• Handle the blade carefully to avoid bending fins or damaging the motor shaft
• The motor shaft and mounting hardware are intact before installation

This front panel is the exterior console trim that restores the appliance's appearance and protects internal controls from everyday wear. It provides a clean, finished surface and secures the control area. What it does:

• Replaces a cracked, warped, or cosmetically damaged front console
• Covers and protects internal control components from spills and debris
• Restores proper mounting surfaces so buttons, switches, or displays align correctly
• Helps prevent exposed wiring or sharp edges at the appliance front

• Disconnect power to the appliance before beginning service
• Remove any trim pieces or mounting screws to access the front panel; keep fasteners for reinstallation
• Handle edges carefully to avoid cuts; plastic may have sharp mounting tabs

This door gasket is a flexible replacement seal that restores a tight refrigerator door seal to help keep cold air in and reduce energy loss. Designed to fit OEM specifications for a direct-fit replacement. What it does:

• Creates an airtight seal around the refrigerator door to help maintain consistent internal temperature
• Helps prevent frost buildup and reduces compressor run-time caused by air leaks
• Restores proper door closure for improved food preservation and energy efficiency
• Common symptom: visible gaps, damaged or cracked seal, or cold air leaking from the door

• One replacement door gasket

• Inspect mounting flange and channel for damage or debris before installing; clean surfaces for best seal
• Typical install requires removing the old gasket and seating the new gasket into the door channel; use gentle, even pressure to avoid overstretching
• If gasket is difficult to seat, warming it slightly with a hair dryer on low can improve flexibility (avoid overheating)
• Disconnect power only if required by your specific model's service instructions and follow all safety precautions