Parts for Lg LP1010SNR: Room A / C Parts

This plug seals the drain outlet on a room air conditioner unit, preventing condensate water from leaking out when drainage is not needed. It fits into the drain port on the back or bottom of the unit. Replace if the plug is cracked, missing, or no longer seals properly, which can cause water to drip or leak from the unit.

This plug seals the drain outlet on a room air conditioner unit, preventing condensate water from leaking out when drainage is not needed. It fits into the drain port on the back or bottom of the unit. Replace if the plug is cracked, missing, or no longer seals properly, which can cause water to drip or leak from the unit.

This base assembly is the cabinet-level support that secures the washer's internal components and helps stabilize the machine during operation. Replacing a damaged base restores proper support and reduces excessive movement. What it does:

• Provides the structural mounting for the tub, motor and suspension components to keep parts aligned
• Helps control vibration and movement during spin cycles
• Maintains proper clearance and routing for hoses and wiring at the cabinet bottom
• Can prevent rubbing, scraping or misalignment-related noise caused by a cracked or warped base

• One base assembly (cabinet base) as shown

• Disconnect power and turn off water before beginning any repair
• Drain the washer and remove panels as required to access and replace the base
• This part is heavy and may require two people and basic hand tools to install

This base assembly is the lower cabinet component that supports and protects the appliance's internal parts, restoring a secure, finished base and helping reduce vibration and movement. What it does:

• Provides a stable mounting platform for internal components and helps keep them protected from debris.
• Restores the appliance's lower cabinet alignment and fit for a flush appearance.
• Can reduce rattling, vibration, or shifting caused by a damaged or missing base.
• Protects lower electrical and mechanical parts from contact and incidental damage.

• Disconnect power and water before beginning work.
• Remove access panels or trim to reach mounting fasteners; keep track of screws and clips.
• Use proper tools and follow the appliance service manual for reassembly.

Air conditioner won't start or shuts off unexpectedly? This overload protector guards the compressor from damage. Moderate DIY repair in 30-45 minutes.