Roper Range Bumper, Bushing, Grommet Parts

Small cushioning bumper for gas range contact points. Absorbs impact and prevents metal-to-metal contact on doors, drawers, or racks. Replace if worn or missing.

Small rubber bumper that cushions range components to reduce noise and prevent metal contact. Replace worn, cracked, or missing bumpers to protect finishes.

Push rivet bumper for range installation. Secures panels and components in place. Replace if missing, cracked, or worn to restore proper fit and finish.

Replace the handle spacer on your range door. This small plastic component maintains proper spacing between the handle and door surface. Order now.

Plastic spacer that fits between range door panels to maintain proper spacing. Replace if cracked, broken, or missing to restore door alignment.

Spacer component for oven doors. Maintains proper door alignment and spacing. Replace if cracked, broken, or missing to restore correct door fit.

This replacement bumper cushions and protects appliance panels and doors to reduce vibration, prevent chipping, and stop rubbing or rattling. It restores a quiet, secure fit where the original bumper has worn or fallen off. What it does:

• Acts as a soft stopper to prevent doors, drawers, or panels from banging or contacting metal surfaces
• Reduces vibration and rattling during operation
• Protects finishes from chips, scratches, and wear at contact points
• Helps restore proper alignment and snug fit where the original bumper is missing or compressed

• One replacement bumper (1 count)

• Clean and dry the mounting surface; remove any old adhesive or debris before installing
• Press the bumper firmly into place; some bumpers use adhesive backing or fit into a recess—verify fit before final placement
• If adhesive is used, allow time for proper bonding per adhesive instructions; avoid using the appliance until secure
• For safety, disconnect power to the appliance before accessing panels or doors

This push-type plastic rivet is a small fastening clip that secures trim, panels and lightweight components on appliances. It replaces worn or broken rivets to restore a snug fit and reduce rattles or loose trim. What it does:

• Secures interior or exterior trim, panels and access covers
• Holds wiring harnesses or insulation in place where a low-profile fastener is required
• Replaces missing or damaged rivets that cause loose panels or vibration noise
• Simple push-in design creates a firm hold without screws or adhesives

• Disconnect power to the appliance before working on panels or wiring
• Push the rivet stem into the hole until it snaps; remove by prying out the center pin or using pliers
• Use the same style and size rivet as the original to ensure proper fit and retention
• Protect surrounding surfaces from tools and work deliberately to avoid damage

This radiant element spacer positions and insulates the burner element under a glass-ceramic cooktop so the element stays secure and heat is directed properly. It helps maintain safe clearance and stable element alignment for consistent cooking. What it does

• Keeps the radiant heating element properly spaced from the cooktop surface and surrounding parts
• Provides electrical/thermal insulation between the element and mounting surface
• Prevents element wobble, rubbing, and noise caused by a loose or damaged spacer
• Helps avoid uneven heating related to misaligned or sagging elements

• One radiant element spacer

• Disconnect power to the range at the breaker before any service
• Handle the cooktop glass carefully to avoid cracks or scratches during removal/reassembly
• Inspect adjacent mounting hardware and the element for wear; replace any damaged parts