Roper Refrigerator Parts

A small metal retaining clip that secures a bi-metal thermostat or temperature sensor in place, helping maintain proper contact and accurate temperature sensing for reliable appliance operation. Simple, durable replacement part. What it does

• Holds a bi-metal thermostat or temperature sensor firmly against its mounting point or probe.
• Maintains consistent contact to support accurate temperature sensing and control.
• Can help stop intermittent temperature-related issues caused by a loose or damaged clip.
• Designed for direct replacement where a spring-style or formed metal retainer is required.

• One bi-metal retaining clip (single clip).

• Disconnect power to the appliance before attempting any repair.
• Removal/installation typically requires small pliers or a flat screwdriver; avoid excessive force to prevent damage.
• Verify clip orientation and that the sensor/thermostat is seated fully before securing.

This replacement cover restores the appliance's finished appearance while protecting internal components from dust and debris. It provides a clean, secure barrier so panels stay in place and the appliance looks and functions as intended. What it does:

• Protects internal parts and wiring from exposure to dust, moisture, and accidental contact
• Helps keep panels securely in place to prevent rattling or loose trim
• Restores the appliance's exterior appearance after damage or loss
• Commonly replaced when the original cover is cracked, broken, bent, or missing

• One replacement cover

• Disconnect power (and water, if applicable) before starting any repair
• Use basic hand tools; support panels to avoid dropping or scratching surfaces
• Handle edges carefully; some covers or mounting points may be sharp
• Refer to your appliance's service manual or parts diagram for exact placement and fastener locations

Wiring harness that connects dispenser components in your refrigerator. Replace if wires are damaged, frayed, corroded, or connections are loose or broken.

Fix a refrigerator that won't cool or runs constantly with this compressor overload protector. Prevents motor damage from overheating. Easy DIY fix.

Fix a refrigerator that cycles on and off repeatedly or won't start with this compressor overload protector. Resolves short-cycling startup issues.

Control box housing for top-mount refrigerators. Protects internal controls and wiring. Replace if cracked, broken, or missing to restore proper coverage.

Black center hinge shim for refrigerator doors. Replaces worn, cracked, or missing shims that support proper door alignment and spacing at the hinge.

Replacement mounting screw for refrigerator panels and components. Needed when original screw is stripped, missing, or damaged during repairs or maintenance.

Support frame for refrigerators. Mounts internally to provide structural support. Replace if cracked, broken, or damaged to restore proper alignment.

Door shelf support rail for side-by-side refrigerators. Mounts inside the door to hold shelves and bins. Replace if cracked, broken, or missing.

Wire harness for refrigerators. Connects electrical components inside your appliance. Replace if wires are frayed, damaged, or causing connection issues.

Secures and supports internal components in your refrigerator. Replace if bent, broken, or missing to restore proper alignment and stability.

Wire harness for side-by-side refrigerators. Connects electrical components throughout the unit. Replace if wires are frayed, damaged, or broken.