Roper Washer Dryer Combo Parts

Motor pulley for dryers. Mounts on the motor shaft to drive the drum belt. Replace if cracked, worn, or causing belt slippage during operation.

Washer won't stop spinning smoothly or makes loud jerking noise when stopping? The brake shoe stops the tub during spin cycles. DIY repair in 1-2 hours.

This retainer clip secures a component in place to prevent movement and maintain proper alignment during appliance operation. Replacing a damaged or missing clip helps restore safe, reliable performance.

• Holds the mating part firmly to reduce vibration and noise
• Helps prevent intermittent operation caused by loose fitment
• Common fix when a component feels loose, rattles, or won't stay seated

• Disconnect power and shut off gas/water before servicing
• Note original clip orientation and location before removal
• Use needle-nose pliers to carefully release and install the clip
• Do not over-bend the clip; replace if deformed or fatigued

This motor connector housing is the molded body that holds the motor's wire terminals for a secure, insulated connection. Replacing a cracked or heat-damaged housing helps restore reliable motor operation and prevent intermittent power issues.

• Organizes and insulates the motor's wiring terminals
• Locks the harness to the motor for a firm electrical connection
• Helps reduce loose contacts, arcing, and heat damage at the plug
• If the housing is failing, you may see intermittent or no motor operation, the machine stopping mid-cycle, or visible melting/discoloration at the motor connector

• Disconnect power; also shut off gas supply
• Note wire positions; transfer terminals into the new housing one at a time to maintain orientation
• Inspect terminals and wiring; replace any burnt or loose terminals before reassembly
• Ensure the connector seats fully on the motor and the harness is secure; restore power and test

Flexible water hose that transports water between laundry center components. Replace when original hose is cracked, split, leaking, or worn out.

Supports the washer transmission shaft to reduce axial wear and noise. Replace when you hear grinding sounds or experience rough operation. Confirm fit with your model number.

Mounting bracket that secures and stabilizes internal washer components. Replace if broken, cracked, or damaged to restore proper panel alignment.

Extends your dryer's exhaust duct to reach distant venting points. Replace if your current extension is crushed, kinked, or too short for proper routing.

Replacement shaft sleeve bushing for washers. Fits over rotating shafts to reduce friction and protect surfaces. Replace when worn, cracked, or missing.

Directs water from your washer to the drain outlet. Replace this tube if cracked, clogged, or leaking to prevent water pooling and potential damage.

Use with motor 357282.

Protective cover that shields the manifold assembly from dust and debris. Replace if cracked, broken, or missing to restore a secure, finished look.

Right-side lid hinge for washer top-loading models. Replaces cracked, broken, or worn hinges that cause lid misalignment or difficulty opening and closing.

Replacement mounting screw for securing panels, brackets, and components inside your appliance. Needed when original screws are stripped, lost, or damaged.

The washer counterweight spring bracket is a metal bracket that secures the springs used to suspend and balance the wash drum inside your washing machine. It keeps the drum centered during the spin cycle, reducing vibration and noise. Replace this part if your washer is shaking excessively, making a loud banging noise during spin, or if you can see that a spring has detached from a broken or bent mounting point.