Ross R Hanford , CA September 08, 2015 Was getting a dc code on samsung washer during spin cycle Changed all 4 damper rods that support the tub. Can't tell by just looking at them if there bad. Took them off and replaced them 1 at a time. Very easy to do. Was not sure if this was going to fix the error code or not but I haven't had a problem since. Read More... 6 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers
Patricia J Salt Lake City , UT April 24, 2016 Trouble running through the spin cycle Made absolutely sure that the machine was level. When the problem persisted, I ordered and replaced the four damper rods. It was a very easy job to replace these parts. The problem is solved!!! Read More... 5 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes
Ken F Tallahassee , FL November 26, 2016 Out of balance dc code Easiest home appliance repair I have ever done. Read More... 2 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers
Sterling C Midland , GA February 20, 2016 Appliance: Samsung Washer WA484DSHASU/A1-0001 Out of balance frequently The support rod replacement did the trick. I used the video and while the clips were a little different on my model, and there were 4 of them (2 in front and 2 on the front sides) the repair fixed the problem. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers
Janice M Wrightstown , NJ February 25, 2018 The dc code would come on when the clothes would do the spin cycle, almost at the end. I had to replace the stabilizing rods on each side of the drum. Read More... Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers, Socket Set