Jeffrey H Golden Valley , MN April 28, 2017 Appliance: Samsung Washer WF42H5000AW/A2-0000 Samsung front load washer no power at control panel after power outage After a power outage the user control board on my Samsung WF42H5000AWA2 failed to light up when the power button was pressed. The washer has 3 boards, user control, motor drive and main. The main and motor drive boards had blinking red LED's so my first thought is was the user control board. After reading other reviews on this site I decided to replace the main board first. This was the problem. After replacing the main board the user control board lit up and the washer worked perfectly again. To replace the main board, unplug the machine, remove the two screws holding the center back panel in place, the boards are located in a plastic housing in the very bottom of the machine below the drum. Remove the two screws to release the board housing. snap open the housing and detach the main from the motor board and unplug all the connectors on the main board. The main board is the larger of the two boards. Reverse to install the new board. Top notch service from Appliance Parts Pros. Ordered the part shipped next day and it was at my house the next morning. Great service! Read More... 22 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
Anthony K Carnesville , GA April 14, 2016 No power New main control board Read More... 4 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
Kevin S Holliston , MA June 20, 2016 Appliance: Samsung Washer WF42H5000AW/A2-0000 Will not turn on no powwe indication at all this happened after a power failure I replaced the main board Read More... 2 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
Matthew B Miami Beach , FL April 02, 2021 Appliance: Model SAMSUNG WASHER User interface slowly died then the whole washer stopped working. New user interface board and control board. The most difficult part was unstacking the drier. There are youtube videos that show how to replace these motherboards. Read More... 2 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 2+ hours Tools: Adjustable Wrench, Pliers, Screwdrivers