Samsung DA67-02787A Refrigerator Freezer Handle End Cap OEM Part

Replaced broken handle support bracket (part #AP5620448) and cap (part #AP5620751). Used a phillips head screwdriver and allen wrench. Pliers also came in very handy. If replacing cap and support bracket, be sure to install cap before support bracket, otherwise you'll have trouble installing the cap. I ended up not needing to replace the fixer handle (part #AP4372038), but I'll keep it around just in case.

I watched the videos and bought the parts I needed then replaced them

I replaced the two end pieces (which had broken) and reset the set screws.

Ordered parts to reattach the handle online. I ordered an array of parts totaling $60, including 2 nylon pins that may have been right and left. Only one worked so hopefully that was the reason - not clear on the parts list. End caps are plastic and broken tabs trying to put them on so they are glued in place. Bolt also had to be replaced and was already taped with Teflon, presumably from the original Samsung install, and might have been the reason for the handle failure. Anyway, all is well and word to wise it is fixable but it will use more parts than you think it will need.

Freezer door handle was easy. Remove broken parts, install new parts, re-install. Note: Buy the handle end caps, they're really easy to snap the tabs off when removing off your old hardware. The ice chute/gasket assembly didn't come out of the door easily (I ended up ripping the gasket and breaking plastic parts) Installation of the new one was easy and it definitely took some effort to get it fully snapped into place, which would explain why it was so hard to get the original out.