Microwave Face Frame Parts

This door frame assembly replaces a damaged or worn outer door trim to restore proper sealing and appearance on compatible laundry appliances. It provides a clean, finished edge for the door and helps the door close evenly. What it does:

• Replaces the appliance's outer door frame to restore correct door alignment and fit
• Supports the door outer panel and provides the finished exterior surface
• Helps maintain the door seal by ensuring the door closes evenly
• Commonly used when the door frame is cracked, warped, or cosmetically damaged

• One door frame assembly (white) as pictured

• Basic disassembly of the door is typically required; keep screws and small parts organized
• Inspect hinges, latch, and inner panel while the door is open to confirm no additional damage
• Follow manufacturer instructions and disconnect power (and water, if applicable) before starting

Black outer door panel for microwaves. Replaces scratched, dented, or faded door surface to restore appearance and protect internal components.

White door frame assembly for your microwave. Replaces cracked, broken, or discolored frames on the microwave door exterior. Direct fit installation.

This base plate assembly provides the lower structural support for the appliance's cabinet, helping keep internal components aligned and stable for reliable operation. It replaces a damaged or bent base to restore proper fit and clearance. What it does:

• Secures and aligns motors, blower, and other under-cabinet components
• Helps maintain proper airflow by holding internal parts in correct position
• Reduces rattling or vibration caused by a damaged or misaligned base
• Prevents contact between moving parts and the cabinet floor that can cause wear or noise

• Disconnect power (and water, if applicable) before beginning any repair
• Follow the appliance service manual for disassembly and reassembly steps
• Verify orientation and fastener locations during install to ensure proper fit
• If other components show wear or damage, inspect and replace them as needed