Microwave Panel Parts

The Reflector is an OEM part for Whirlpool microwaves. It is located inside the microwave cavity behind the waveguide and works to redirect electromagnetic waves for more even cooking.  

Symptoms of a damaged reflector include:

• Inconsistent or incomplete heating of foods during cooking
• Hot and cold spots forming within the microwave cavity
• Lower overall power output from the microwave

Causes of reflector damage can be cracking or pitting of the reflective aluminum surface over multiple heating cycles. Impact incidents from user error may also damage its shape.

This OEM Whirlpool replacement assists in delivering uniform energy distribution for optimal microwave performance. This part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, and Roper microwave models.

The Vent Damper is an OEM part for Frigidaire microwaves. It is designed to control the flow of air through the microwave’s ventilation system, ensuring proper ventilation during operation. This component helps to prevent the backflow of air, keeping the microwave's interior and its surroundings free from unwanted odors and heat.

Causes of a bad vent damper can include wear and tear over time, accumulation of grease or debris, or damage from external impact. 

Symptoms of a bad vent damper include:

• Poor ventilation
• Unusual odors lingering around the microwave
• Excessive heat buildup
• Increased noise during operation

This OEM Frigidaire part is also compatible with Electrolux, Gibson, Kelvinator and some Kenmore models.

This replacement frame restores the appliance's front trim and secures the control/door area for a finished look and proper panel alignment. Use it to repair bent, cracked, or loose trim and return the unit to safe, stable operation. What it does:

• Replaces damaged or warped front cabinet trim to restore proper panel fit and appearance
• Secures the control panel/door edges and helps maintain correct alignment
• Prevents gaps that can collect dirt or interfere with door operation
• Common symptom: visible cracks, dents, separation or loose trim around the front panel

• One replacement frame

• Disconnect power to the appliance before starting any repair
• Remove exterior trim screws or clips holding the old frame; retain fasteners unless replacements are provided
• Handle edges and any attached glass or plastic carefully to avoid damage or injury

This replacement frame restores the appliance's front cabinet trim for a finished look and secure component fit. It helps protect internal parts and keeps the control area or door edges properly aligned. What it does:

• Replaces damaged, cracked, or warped front trim that affects appearance or fit
• Secures adjacent panels and provides a mounting surface for controls or seals
• Helps stop drafts or gaps that can form around doors or control openings
• Restores proper alignment to reduce rubbing or interference with moving parts

• One replacement frame as pictured

• Disconnect power (unplug or switch off breaker) before starting any repair
• Basic hand tools (screwdriver, nut driver) are typically required; keep fasteners for reuse if intact
• Handle edges carefully to avoid scratching the finish; protect surrounding surfaces during installation

This door frame restores the outer trim that secures the refrigerator door assembly and improves fit-and-finish. It replaces a cracked, warped, or damaged outer frame to restore proper door alignment and appearance. What it does

• Replaces the outer trim that surrounds and supports the door assembly
• Helps maintain proper door alignment and sealing when the original frame is damaged
• Addresses visible cracks, dents, or separation around the door edge
• Prevents further damage to the door shell and mounting points

• One door frame (outer door trim) as shown

• High-level: remove the door from the appliance per manufacturer instructions before replacing the frame when required
• Use care to avoid scratching the door finish; soft surface and proper fastener handling recommended
• Tighten fasteners to manufacturer torque specs if provided; do not overtighten