665153900 Parts

Shield for dishwashers. Protects internal components from water and debris. Replace if cracked, broken, or missing to maintain proper coverage.

Replace your dishwasher's main tub assembly if cracked, warped, or leaking. This structural component forms the interior wash chamber of your unit.

Dispenser won't latch or close? This detergent dispenser releases soap at the right time. Moderate DIY repair requiring inner door panel removal.

Fix a detergent dispenser door that won't open or latch properly. This dishwasher dispenser assembly replaces broken latches and leaking units.

This hose clamp secures dishwasher hoses to fittings and ports to maintain a tight, leak-resistant seal. Replacing a worn clamp helps prevent drips and loose connections that can cause water under the unit.

• Secures drain or circulation hose to the pump, sump, or other dishwasher fittings
• Helps maintain a watertight seal at hose connection points
• Can help resolve water dripping from a hose joint or a loose hose
• Replace if corroded, deformed, cracked, or no longer holds tension

• Disconnect power and turn off the water supply before servicing
• Place a towel or shallow pan to catch residual water when removing hoses
• Fully seat the hose on the fitting, position the clamp over the barb/connection, and secure firmly
• After reassembly, run a brief fill/drain and check all connections for leaks

Dishwasher won't start or lights flashing? The electronic control board manages cycles and timing. Moderate DIY repair restores full operation.

Replacement outer door panel cover for dishwashers. Restores exterior appearance and shields internal components. Needed when original is cracked or damaged.

Insulation pad that fits behind dishwasher panels to restore thermal protection and reduce noise. Replace if damaged, missing, or rattling occurs.

Fix intermittent power issues or loose connections in your dishwasher. This wire connector restores secure electrical contact between components.

Filters debris from water to protect pump and spray arms. Replace if you notice slow drainage, poor cleaning, or water left in tub. Verify fit by model.

Supports and guides your dishwasher rack for smooth rolling. Replace if rack binds, derails, or won't pull out fully. Confirm fit with your model.

Fix dishwasher overfilling or leaking issues. This float assembly monitors water level and signals when to stop filling. Simple DIY repair.

Replaces your dishwasher's cracked, warped, or damaged interior door panel. Restores structural support, secures insulation and inner glass properly.

Replacement clip that secures the dispenser guard on compatible Whirlpool refrigerators. Replacing a damaged or missing clip restores a secure dispenser trim and can reduce rattling or misalignment around the dispenser area. What it does:

• Secures the dispenser guard/trim to the dispenser assembly to keep the trim aligned.
• Commonly needed when the guard is loose, rattling, cracked or falls out.
• Replaces broken or missing clips that allow the dispenser trim to move or vibrate.
• Helps restore proper fit of the dispenser trim so the dispenser components sit flush.

• Disconnect power (unplug or turn off the circuit) and shut off the water supply if working near the water/ice dispenser.
• Remove the dispenser trim or guard per the model's service instructions; handle plastic parts gently to avoid cracking.
• Align the clip with the mounting slot and engage until seated; if access is limited or the guard is damaged, follow safety guidelines when servicing appliances.

Fix intermittent operation or complete failure caused by frayed or corroded wiring. This wire harness restores power connections between control and components.