80131900 Parts

This spring-style hose clamp secures flexible appliance hoses and helps prevent leaks by holding hose ends tightly to fittings. Reliable, low-profile design for use on drain, water, or vent hoses where a strong, consistent grip is needed. What it does:

• Provides a spring-tensioned grip to keep hoses seated on fittings and reduce leaks
• Commonly used on flexible drain or water hoses and small vent lines
• Helps maintain proper connection under normal vibration and thermal cycling
• Replaces worn, stretched, or corroded clamps that no longer hold tension

• One spring hose clamp (exact quantity as sold)

• Use pliers to expand the clamp, slide into position, then release to seat on the fitting
• Inspect hose ends and fittings for wear; replace hose if damaged before installing clamp
• Wear eye protection when compressing the clamp; keep fingers clear of the clamp's edges
• Tighten only as needed—over-compressing can damage the hose

This genuine OEM replacement part is a pulley assembly for dryers. Sometimes called an idler arm, the pulley assembly keeps the dryer drive belt under tension as the belt wraps around the dryer drum. If the dryer is no longer spinning properly and is making a lot of noise, the pulley assembly may need to be replaced. Luckily this repair is a relatively simple process.To remove the old dryer pulley assembly, start by making sure the dryer is unplugged. Remove the lint screen from the top of the dryer. Remove the two Phillips screws by the lint screen opening. Depress the clips that hold the top cover down. Lift the top cover and keep it in an upright position. Disconnect the wire harness to the switch that separates the connector. Remove the screws on the front panel. Lift the panel forward and set it to the side. Next, lift the drum and locate the pulley assembly under the drum. Lift the belt off the motor pulley to remove the assembly. Set the new pulley assembly in the same position as the old one and make sure everything is aligned. Rotate the drum to make sure it rotates smoothly. reinstall the panels.This replacement part is sold individually and is compatible with Bosch, Gaggenau, and Thermador dryers.

This replacement control panel window is the clear front lens that covers and protects an air conditioner's control/display area while keeping buttons and indicators visible. It restores a clean, readable appearance and protects internal controls. What it does:

• Replaces a cracked, scratched, fogged or missing control panel lens so displays and buttons are visible
• Shields internal controls and electronics from dust, moisture splashes, and everyday wear
• Maintains original fit and appearance for the unit's control area
• Helps preserve resale value and user usability by restoring a finished front surface

• One control panel window (1 piece)

• Disconnect power to the unit before starting any work
• Usually installs from the front; may require removing outer trim or bezel and a few screws or clips
• Handle the lens carefully to avoid scratches; use soft gloves and a non-abrasive surface during installation
• Inspect seals and replace if compromised to maintain weather protection

This ignition set consists of an ignition breaker and condenser. It is made of durable materials and uses a mechanical switch to close the electrical system and make a spark. If these parts are not working correctly or are broken, the engine on the lawn equipment will not start so the machine cannot be used. If the ignition set might not be working, use a spark tester with a plug lead to test. Place the control on stop or shut it off and attempt to turn on the engine using a key or cord. There should be no spark. When in the on position, a spark should be present. If the spark doesn't occur, there may be broken wires, grounds, shorts, or defects, so the parts will need to be replaced.This ignition set is a genuine OEM replacement part that was sourced directly from the manufacturer. It is sold as a single kit. The part is designed to be used in lawnmowers, tillers, leaf blowers, and snowblowers created by Cub Cadet, Briggs & Stratton, Broan, Lawn-Boy, and Toro.