862A300p120 Parts

This thermostat knob replaces a worn or broken control knob so you can set oven temperature accurately and safely. It restores a secure grip and smooth rotation for reliable temperature selection. What it does:

• Fits onto the oven/range thermostat shaft to select temperature settings
• Replaces cracked, stripped, or loose knobs that don't turn or hold position
• Helps restore accurate user control when the original knob is damaged
• Works with manual rotary thermostat controls (shaft-style)

• One thermostat control knob

• Disconnect power to the appliance before attempting any service
• Pull the old knob straight off the shaft and push the new knob fully onto the shaft until seated
• Do not force the knob if it feels misaligned; check shaft adapter orientation and match flat sides
• If underlying shaft or switch is damaged, replace the underlying control assembly rather than forcing the knob

This wire harness connects the run capacitor to the appliance's electrical system, providing a reliable path for start/run signals so the compressor and fan can operate correctly. It replaces a damaged or worn connector harness. What it does:

• Routes electrical connections between the run capacitor and control components
• Helps ensure proper start/run performance for compressor and motor circuits
• Prevents intermittent operation caused by corroded or loose wires
• Commonly replaced when wiring is visibly damaged or appliances fail to start reliably

• One run capacitor wire harness

• Always disconnect power before servicing electrical components
• Inspect the capacitor for stored charge and discharge safely before disconnecting harness leads
• Match connector ends and wire routing to original harness; avoid stretching or pinching wires

This vertical door seal runs along the sides of the oven door opening to keep heat contained. Replacing a worn side gasket restores a tight seal for more consistent temperatures and efficient baking performance.

• Seals the side edges of the oven door to reduce heat loss and maintain set temperature
• Helps the oven preheat properly and bake more evenly
• Replaces side gaskets that are torn, frayed, hardened, or permanently compressed
• Common signs include visible gaps or tears, heat escaping at door edges, longer preheat times, and temperature fluctuations

• Disconnect power (and shut off gas, if applicable). Allow the oven to cool completely.
• Remove the old side seal from its channel or clips; note routing and orientation.
• Clean the channel. Press the new seal into place without stretching; ensure ends/clips are fully seated.
• Close the door to confirm uniform contact along both sides; reseat as needed.

A removable cap that covers the freezer's defrost drain hole, typically located at the bottom rear of the freezer compartment. Replace when water pools in the freezer, the cap is missing, or ice blocks the drainage system.