Ade8060 Parts

Front bulkhead assembly supports the drum and front bearing in your dryer. Replace if you notice excessive vibration, air leaks, or rubbing noises. Confirm fit with your model number.

Replace this dryer belt switch harness if your dryer won't start or stops mid-cycle. Detects broken belts and prevents motor damage. Verify fit with your model number before ordering.

Connects control components and provides indicator light for proper dryer operation. Replace if lights malfunction or controls fail. Verify compatibility.

This is a tapping screw with a hex head and Torx drive designed to fasten panels and components on Speed Queen laundry appliances. It provides a secure, vibration-resistant hold for repeatable service and repairs. What it does

• Fastens outer panels, brackets and internal parts where a self-tapping screw is required
• Holds components tight to prevent rattling or misalignment during operation
• Replaces missing, worn or stripped screws that cause loose or insecure parts
• Used when a screw must tap its own threads in sheet metal or thin substrates

• One tapping screw (hex head Torx)

• Use the correct Torx driver bit to avoid stripping the drive recess
• Drive straight and steady; do not over-torque to prevent thread or sheet-metal damage
• Follow OEM service instructions for panel removal and fastening order
• Disconnect power and follow safety precautions before servicing the appliance

A replacement low-profile Phillips screw used to secure panels and components on compatible laundry equipment. Provides a secure, low-profile fastening where a shorter head is required. What it does:

• Fastens trim, control panels, or small brackets where a low-profile head is needed
• Restores secure attachment when original screws are missing or stripped
• Helps eliminate rattling or loose panels caused by missing hardware
• Matches common #8 AB-18 x 1/2" thread and length for specified OEM fittings

• Use the correct Phillips screwdriver to avoid cam-out and head damage
• Start threading by hand to avoid cross-threading; do not force
• Tighten until snug—do not over-torque to prevent stripping the mating threads
• If threads are damaged, replace with an appropriate fastener or repair the hole before installing

Phillips truss-head screw secures dryer panels, trim, and guards. Replace when stripped, corroded, or missing during repairs. Verify fit with model number.

This left-side cabinet panel restores the exterior side of the washer/dryer cabinet for a clean, finished appearance and cabinet stability. It replaces a dented, rusted, or damaged side panel to improve looks and protect internal components. What it does:

• Replaces a damaged or corroded left cabinet side to restore cabinet strength and appearance
• Covers and protects internal components from dust and accidental contact
• Helps prevent moisture and debris from reaching internal parts that can cause wear
• Returns the cabinet to a flush, finished profile for proper enclosure fit

• One left cabinet side panel (single piece, as shown)

• Disconnect power and water before starting work
• Remove adjacent panels or trim as needed to access mounting screws; keep hardware for re-use unless damaged
• Handle edges carefully—wear gloves to avoid cuts and alignment damage
• Test fit and align before tightening fasteners to ensure proper panel gaps and secure fit