Art1106ll Parts

Wire shelf restores stable storage surface in refrigerator compartment. Replace bent, rusted, or missing shelves to improve organization and maintain space.

This is a small white plastic plug that fills the hinge sleeve hole on a refrigerator or freezer door. It covers unused hinge mounting holes to provide a clean, finished appearance, especially after reversing the door swing. Replace this plug if it has cracked, fallen out, or gone missing, leaving an exposed hole in the door.

Protective thimble bushing that reinforces the hinge pin mounting hole in your freezer door liner. Replace if worn, cracked, or missing to stabilize hardware.

Door hinge butt for top-mount refrigerators. Mounts between cabinet and door to support hinge pin assembly. Replace if cracked, broken, or worn out.

Protective seal grommet for hoses, tubes, or wires passing through refrigerator cabinet. Replaces cracked, worn, or missing grommets to prevent leaks.

Fix dim or no interior lighting with this refrigerator light bulb. Restores clear visibility when you open the door. Simple 5-minute replacement.

This orifice is a small precision component used in the refrigerator's cooling system to regulate refrigerant or gas flow. It is typically located near the evaporator or cooling circuit and helps control the rate at which refrigerant enters the evaporator coil. Replace this part if the refrigerator or freezer section is not cooling properly, frost patterns are uneven, or a technician has identified a restricted or damaged orifice during diagnosis.

Channels defrost water from the drain outlet to the pan. Replace if cracked, disconnected, or clogged to prevent water pooling inside or leaking onto floor.

Replacement mounting screw for refrigerator panels, brackets, and trim. Restores secure fit when original screw is stripped, missing, or damaged.

Touch-up paint for appliances. Covers chips, scratches, and worn areas on range tops, refrigerators, and other appliances. Includes brush applicator.

Fix temperature fluctuations or cooling issues in your refrigerator with this thermostat. Quick DIY repair, typically takes under 5 minutes to install.

Replacement hinge pin that acts as the pivot point for your refrigerator door. Install when the original pin is worn, broken, or missing.

Flat washer used on refrigerator door hinge assembly. Reduces friction and distributes load for smooth door operation.

This replacement screw secures panels, brackets, and other components in your appliance so they stay tight and properly aligned. Use it to replace missing, stripped, or rusted hardware and eliminate looseness, rattles, or gaps.

• Fastens parts to the cabinet/frame to maintain structural integrity
• Helps keep panels and assemblies aligned to reduce vibration and noise
• Replaces missing, damaged, or corroded screws during service
• Common fix for loose panels or components that no longer hold securely

• Disconnect power and shut off water or gas before servicing
• Match length and thread to the original screw for proper fit
• Hand-start threads to avoid cross-threading; tighten only until snug—do not overtighten
• Tighten them evenly to ensure proper alignment

Replace your refrigerator door gasket to restore proper sealing and prevent cold air loss. Stops frost buildup, condensation, and temperature swings. Verify fit by model number before ordering.

Size: 8-18 x 1/2 inch.