Your privacy choices: We and our partners use cookies for analytics and ads. Decline all turns them off.
Privacy Policy · Do Not Sell or Share My Personal Information
Need Help?
Call
I bought replacement hinges and installed them myself. The hardest part of the job was the first part: to remove the oven door you have to lock the old hinges with small brackets, and one side did not want to lock--I had to use a hammer. The door was heavier than it looks, but the only challenge after that was the fact that the edges of the door parts were sharp. I probably should have worn gloves when handling them. You have to take the door apart to insert the new hinges, but it's just... Read more
This tempered glass cooktop surface provides the cooking platform for electric ranges with smooth-top burners. It houses the heating elements underneath and creates a flat, easy-to-clean cooking surface. Replace if the glass is cracked, shattered, or has burn marks that won't clean off.
Followed the directions posted as an answer to Paul's question. Wasn't too bad, took about an our. The one problem I had was that the burners wouldn't ignite at first. I had to go back and tighten the hex nut screws holding down the black burner caps to get the igniter sparks closer to the metal surrounds so that the arc went straight up instead of to the sides. Read more
The igniter switch and harness assembly is the wiring and switch set that sends an electrical signal to the igniter when you turn a burner knob on your gas range. It connects the control knobs to the spark module, triggering the clicking sound and spark that lights the burner. Replace this part if a burner won't spark, sparks continuously on its own, or if clicking persists even after the burner is lit.
After replacing the burner twice and verifying the fuel holes and orifice was not blocked, we fixed the problem by replacing the wiring harness P/N: AP3965774. That and making sure the burner was tightly screwed into the range base to ensure the correct spark gap. Read more
Ordered a new clock/timer control. This was very easy to install the real trick was removing about 8 wires and 4 plug in connectors from the board and then reinstalling them back in the same location as the were before. I took a photo of the board with my IPhone before taking all the wires off, this made it very easy to reinstall the wires on the same terminals as before. There are 2 additional connectors on the board that a flat ribbon cable from the touch button panel attaches to. Do not just... Read more
Replaced both door hinge receptacles Read more
Opt-Out Request Honored
We use cookies to optimize website functionality, analyze the performance, and provide personalized experience to you. Use the controls below to manage your privacy preferences.
Cross-Site Advertising
When enabled, we may use cookies and similar technologies to deliver personalized advertisements based on your browsing activity across different websites. Opting out will disable third-party advertising cookies on this site.
Analytics Sharing
When enabled, we may share anonymized browsing and usage data with third-party analytics providers to help us understand how visitors use our site. Opting out will prevent this data from being shared with third parties.