Dcvh1480ekww Parts

Adjustable leveling leg and bracket assembly for dryers. Installs at the base to stabilize and level your unit. Replace missing, broken, or worn feet.

Replacement mounting screw for dryer panels and components. Needed when original screws are stripped, missing, or damaged during repair or maintenance.

Drum roller assembly for dryers. Mounts to the rear panel to support smooth drum rotation. Replace if worn, squeaking, cracked, or causing wobble.

A replacement control knob assembly that restores safe, positive control of your appliance's settings. Replaces a cracked, stripped, loose, or missing knob so you can select functions and settings reliably. What it does:

• Provides a secure grip and smooth rotation for selecting temperature or function settings
• Replaces knobs that are cracked, worn, stripped, loose, or missing
• Restores proper control engagement when the original will not turn or won't stay set
• Matches OEM fit and mounting for a straightforward swap

• Always disconnect power to the appliance before starting any repair
• Most installations are push-on: remove the old knob by pulling straight off, then push the replacement onto the control shaft until fully seated
• If the knob is tight or stuck, gently wiggle while pulling; avoid prying on surrounding surfaces

Replacement outer glass panel for dryer doors. Restores visibility and finished appearance when original glass is cracked, chipped, or scratched.

If your dryer won't start or the door won't latch, this door strike may be worn or broken. Restores secure door closure. Simple 10-minute fix.

Replace your dryer's hinge bearing if the drum squeaks or wobbles during operation. Ensures smooth drum rotation and proper door alignment. Verify fit with your model number before ordering.

Replace your dryer's door hinge bracket if it's cracked, broken, or causing misalignment. This metal mounting bracket secures the door hinge assembly.

Fix a dryer that won't start or drum won't turn with a new motor assembly. Moderate DIY repair requiring drum removal and electrical testing.

Replacement mounting screw for dryer front panel assembly. Secures front panel to cabinet. Needed when original screw is stripped, missing, or lost.

This is a small M4 x L8 screw used to secure the back panel cover on the washer. It holds the rear access panel firmly in place, keeping internal components protected and enclosed. Replace this screw if it is stripped, missing, or corroded, which can cause the back panel to become loose or rattle during operation.

This rubber mounting pad cushions and isolates appliance components to reduce vibration and noise, helping parts sit securely and run quieter. A simple replacement for worn or damaged pads that lets the appliance operate more smoothly. What it does:

• Acts as a vibration damper to reduce noise and movement during operation
• Provides a stable cushion between metal parts or between appliance and mounting surface
• Helps prevent rubbing, rattling or premature wear caused by metal-on-metal contact
• Commonly replaced when pads are cracked, compressed, missing or deteriorated

• Disconnect power and, if applicable, water supply before accessing internal components
• Inspect mounting area and clean surfaces before installing the new pad
• Press or fit the pad into place; no special tools typically required
• If multiple pads on the same assembly are worn, replace them together for even support