Need Help?
Call or text
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
A small rubber-lined washer that cushions and electrically isolates connections to reduce metal-on-metal contact and damp vibration. Helps protect parts and maintain proper spacing for reliable operation. What it does:
Usually ships within 4 - 14 days
This right-side end cap is the molded exterior trim piece that finishes the appliance cabinet and protects internal edges. It restores a clean, finished appearance and helps keep door and panel seams sealed from dirt and moisture. What it does:
The video was quite helpful with step by step instructions. I ordered a belt and idler pulley before dismantling assuming they were the issues. Belt was easy and fit fine but I did not realize the idler pulley was secured with a special fastener, push on cap nut, that would be damaged if removed. So I left it in place. Original pulley seemed fine so I reassembled the dryer. Restarted and of course the noise remained. I ordered the push on fastener and also the drum bearing as a precaution. ... Read more
The Handle Door is an OEM part for GE dryers. This door handle allows for easy opening and closing of the dryer door, providing a secure grip to access the drum.
Common causes for door handle failure include regular wear from frequent use, forceful handling, and material fatigue over time.
Symptoms of a failing Handle Door include:
This OEM GE part is also compatible with Hotpoint, RCA, and some Kenmore models.
I replaced the rear drum bearing, all four slides, and front top bearing support. Replacement of parts was easy and didn't take that long to do. Problem solved. Read more
It was fast and simple. Pulled off the old one and snapped the new one in place. Took only a couple of minutes. Read more
Easy peezy. Just follow the video. Great company and great prices too.. and very helpful. Read more
Replaced new parts with the new one, swapping one wire at the time. Read more
Replaces a cracked, rusted, or disconnected exhaust duct that routes hot air from your dryer to the home vent. Restores proper airflow and venting.
Removed front of dryer and back access plate allowing me to see that the pipe just slipped over the blower. A small tab in the back cover was inserted inside the left side of the pipe and when I straightened the tab I could move the pipe to the right and then straight out. Replacement of the pipe was the reverse. The new pipe did not have a hole for the tab, so I bent the tab to its original position, and rested the pipe against the tab. The new pipe had a rear flange that kept it in place.... Read more
This motor plate is the stamped metal mounting plate that secures the motor assembly and keeps it aligned for smooth operation. It restores proper motor positioning and reduces vibration-caused noise or wear. What it does:
Front bracket and leveling screw assembly.
This dampening band absorbs vibrations and reduces noise during your washer's spin cycle by cushioning the tub movement. It connects between the tub and the washer cabinet to minimize shaking and rattling sounds. Replace this part if your washer vibrates excessively, makes loud banging noises during spin, or walks across the floor during operation.
The sensor rods harness is the wiring assembly that connects the moisture or temperature sensor rods in a dryer to the main control board, allowing the dryer to detect when clothes are dry. This electrical connection enables automatic drying cycles to shut off at the right time, saving energy and protecting fabrics. Replace this harness if your dryer runs too long, stops too early, or if auto-dry cycles are not working properly.