Dts181crdrww Parts

Wire harness that connects the control module in your refrigerator. Replace if wires are frayed, connectors are damaged, or harness is broken or missing.

Replacement ice maker cover cap for your refrigerator. Installs over the ice maker assembly. Order a new cap if yours is cracked, broken, or missing.

Rear trim for refrigerator glass shelves. Installs along the back edge of shelf to secure and finish the glass. Replace if cracked, broken, or missing.

White corner cap covers and protects exposed refrigerator door edges. Replaces cracked, broken, or missing caps to restore a finished look and prevent wear.

Fix a warm fridge or freezer ice buildup. This defrost heater melts frost on evaporator coils to restore cooling. Moderate DIY repair, 1-2 hours.

Compressor clicks on and off or won't start? This PTC start relay energizes the compressor start winding to restore consistent cooling. DIY-friendly repair.

Half-width crisper drawer for refrigerators with Hammer Head shelf design. Replaces cracked, broken, or missing produce bins in the fresh-food compartment.

Left hand side. For right hand use WR17X10862

This replacement defrost heater warms the freezer's evaporator area during the automatic defrost cycle. It melts accumulated frost so air can circulate, helping maintain stable temperatures and preventing ice buildup on the back wall.

• Heats the evaporator to clear frost and ice during defrost
• Helps keep airflow passages and the defrost drain path open
• Common symptoms of a failed heater: heavy frost on the back panel/coils, poor cooling or warm sections, fan noise from ice contact, cooling returns temporarily after a manual defrost
• Typically located behind the rear freezer panel

• Disconnect power before servicing; wear cut-resistant gloves
• Access the evaporator by removing the freezer's rear panel; thaw heavy ice before removal
• Transfer any clips/brackets and route wires exactly as original, keeping them away from plastic parts
• After installation, ensure wiring connections are secure and the heater is not contacting plastic surfaces

Replaces a cracked or broken freezer tower bottom cover that mounts beneath the evaporator assembly. Directs airflow and protects internal components.

Secures trim and panels in your refrigerator. Replace when broken clips cause loose parts or rattling. Verify fit with your model number.

This holder element assembly secures the appliance's heating element in the correct position so the element stays stable for consistent operation and safe performance. It's a direct-fit replacement for worn or damaged holders. What it does:

• Secures and supports the heating element inside the appliance to maintain proper alignment
• Prevents element sagging or contact with other components that can cause noise or arcing
• Helps reduce vibration and movement that can lead to intermittent heating
• Common symptom: visible holder damage, loose or shifted element, unusual noise during operation

• Disconnect power (unplug or switch off breaker) before starting any repair
• Allow appliance and element to fully cool before handling
• Handle the element and holder carefully to avoid bending or damaging the element

Compressor won't start or runs hot? This overload protector stops your refrigerator compressor from overheating and prevents premature failure.

White plastic corner cap that snaps onto refrigerator door corners to conceal fasteners and protect hinge areas. Replace if cracked, broken, or missing.