Fdb1100rhs Parts

Replacement mounting screw for dishwasher panels and internal components. Needed when original screws are stripped, missing, or corroded during repairs.

Secures the sump assembly and pump seal to prevent leaks and maintain proper water flow. Replace if damaged or during sump repairs. Confirm fit with model.

Replacement mounting screw that secures control switches and switch assemblies to the dishwasher panel. Needed when original hardware is lost or stripped.

Red

Secures dishwasher hoses to prevent leaks and water damage. Replace if loose, cracked, or leaking. Verify fit with your model number before ordering.

This is a small bearing that fits onto the door hinge pin of a dishwasher. It allows the door to pivot smoothly when opening and closing, reducing friction and wear on the hinge assembly. Replace this bearing if the dishwasher door feels stiff, squeaks during operation, or does not stay open at the desired angle.

Replacement mounting screw for dishwasher panels and components. Secures loose panels, brackets, and trim. Needed when original fasteners are missing, stripped, or worn.

Filters debris from dishwasher sump to protect pump and spray arms. Replace if warped, clogged, or dishes aren't cleaning properly. Verify fit by model.

NOTE:  Wheels are no longer included with this part.

Replaces a rusty, cracked, or damaged dishwasher upper rack. Restores smooth gliding and secure loading for cups and bowls on the top level.

This thermistor is the dishwasher's temperature sensor. It reports water temperature to the control so the heater and cycle timing are managed correctly, helping restore reliable wash performance and more consistent drying.

• Monitors water temperature in the tub/sump and sends readings to the control board
• Helps the control regulate heater operation and determine cycle progress/timing
• Failure can result in no heat or poor drying
• May cause unusually long/short cycles or temperature-related fault codes

• Disconnect power at the breaker and shut off the water supply before servicing
• Access is typically from the toe-kick/base area or sump; remove the lower access panel as needed
• Release the locking tab/clip, remove the sensor, and ensure the existing seal/O-ring is properly seated; install the new sensor fully to prevent leaks
• Reconnect the wire harness, restore power, and run a test cycle to check for leaks and proper heating

Protective shield that guards internal dishwasher components from heat and moisture. Replaces cracked, warped, or missing original shields.

Replacement mounting screw for dishwashers. Secures components and panels inside your dishwasher. Order a new screw if yours is stripped, missing, or damaged.

Dishwasher won't start or door won't latch? This handle and latch assembly secures your door and activates switches. Simple 10-minute DIY repair.

Dishwasher buttons not responding or cycles won't start? This control switch assembly restores electrical control and user-interface function.

This is a rubber gasket that seals the area around the dishwasher control panel or door edge, preventing moisture from escaping during wash cycles. It helps protect internal electronic components from water damage and maintains proper door sealing. Replace this gasket if you notice water leaking from the top or sides of the dishwasher door, or if the seal appears cracked, warped, or deteriorated.