Fghf266pf3 Parts

Lower door hinge for bottom-mount refrigerators. Secures the door to the cabinet frame. Replace if cracked, stripped, or causing door misalignment.

Replacement auger nut for bottom-mount refrigerators. Secures the ice auger assembly in the ice maker dispenser. Order a new nut if original is stripped or missing.

Secures and aligns the control console and electronics at the front of your refrigerator. Replace if the bracket is cracked, broken, or missing.

Ice dispenser not crushing or jamming? This refrigerator ice crusher auger blade feeds and crushes ice cubes. Moderate DIY repair in 30-45 minutes.

Replacement spacer for refrigerator fixed blades. Installs between blade components to maintain proper spacing. Replace if cracked, broken, or missing.

This is a gasket that seals around the upper evaporator cover inside the freezer compartment. It helps maintain proper airflow and prevents warm air from bypassing the evaporator coils. Replace this gasket if you notice excessive frost buildup in the freezer, inconsistent cooling, or if the gasket appears torn, warped, or no longer seals tightly against the evaporator cover.

Seals the coil cover area to maintain proper airflow and prevent dust buildup. Replace if worn, cracked, or losing seal efficiency. Verify fit with your model.

This tube connector is a small water-line fitting that joins refrigerator water and ice-maker tubing, restoring a secure path for water flow. It helps stop leaks and regain consistent water delivery to the dispenser or icemaker. What it does:

• Joins two sections of refrigerator water tubing to maintain a watertight connection
• Stops leaks at a damaged or worn tube joint
• Restores water flow to the ice maker or dispenser when a broken connector is the cause
• Compatible with rigid and soft tubing in typical refrigerator plumbing layouts

• One tube connector

• Shut off the refrigerator water supply before servicing
• Inspect tubing ends and replace damaged tubing or seals as needed
• Use proper fittings and tighten to manufacturer torque; avoid over-tightening

Controls airflow between refrigerator compartments by operating the air damper door. Replace if damper is stuck, broken, or fails to regulate temperature.

Foam sleeve insulation that wraps around the refrigerator air duct. Replace worn, torn, or missing insulation to reduce condensation and moisture buildup.

Mounting screw for refrigerator components and panels. Replace if stripped, missing, or damaged during repairs to secure parts properly.

Foam insulation installs in refrigerator cabinet walls and interior surfaces. Replace if cracked, compressed, torn, or missing to restore efficiency.

Internal water reservoir that stores fresh water for your refrigerator's dispenser and ice maker. Replace if cracked, leaking, or frozen solid.

This thermistor kit is the refrigerator temperature sensor assembly that monitors internal air temperature so the control can run the compressor and fans at the right times. Replaces a failed sensor to restore proper temperature sensing and cycling. What it does:

• Detects refrigerator/freezer compartment temperature and sends that signal to the control board
• Helps the control manage compressor and fan runtime for consistent cooling
• Commonly used when the fridge is not maintaining temperature or cycles erratically
• Works as the sensor portion of the evaporator/air-sensing circuit in compatible models

• Disconnect power before servicing to avoid shock or damage.
• Handle the sensor and connector gently; do not kink the sensor lead or damage the probe tip.
• Route the harness and secure clips per the original layout to ensure accurate sensing.