Frigidaire Affinity Pedestal Parts

Control board totally burned. Replaced the control board and got my dryer working again. Read more

Our washing machine door boot seal was getting moldy and causing odor problems. Cleaning tablets and bleach weren't helping so it was time to be replaced. While I had the top and front off I changed all the hoses that could be collecting soap scum and mold, all other wetted parts were removed and washed. The video on the door boot seal, and inlet valve assembly were extremely helpful in understanding how these parts are removed and reassembled. Although the door boot seal is the most visible... Read more

My washer would beep nine times then pause for a few seconds then beep again. To remedy this before ordering a new control board, I had to remove the top cover of the washer, keep the power on and heat the control board with a hair dryer. Once the board was nice and hot, I would unplug the washer and plug it back in. This allowed the error code to be removed and the beeping to stop to where I could use the washer. I replaced the washer control board and all is well again! Read more

I believe the shock absorbers were bad and caused too much stress on the spring, breaking it. I replaced the spring, spring protector, and shock absorbers. I got lucky; when I got the drum back up where it belonged I saw that the door boot seal straightened itself back out and wasn’t damaged so I didn’t have to replace it. The whole job took about three hours and the washing machine runs more smoothly now than it did when it was new! Read more

Follow instructions on internet. The only issue was the flat head allen drive screw securing the belt pulley to the shaft. Rounded the allen drive and wrench. Drilled two holes on opposite sides of allen drive hole. Elongated to make a long slot. Used impact driver to remove screw. Read more