Need Help?
Call or text
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
The Idler Pulley is an OEM part for Frigidaire dryers. It helps guide and maintain tension on the dryer drum belt, ensuring the drum rotates smoothly during the drying cycle.
Over time, the idler pulley can wear out due to friction and regular use, or it may become damaged from excessive strain or misalignment. If the idler pulley fails, the dryer drum may not rotate properly, leading to inefficient drying or a complete inability to dry clothes.
Symptoms of a bad Idler Pulley include:
This OEM replacement is also compatible with Electrolux, Gibson, Kelvinator, and Kenmore models.
I replaced the spin bearing, tub seal, washer and drive belt since I had it all apart. The video was extremely helpful...I would have tore the whole thing apart trying to figure out how the agitator came off....but it was very simple. Read more
The trunnion is the hub that mounts the washer's inner tub to the drive shaft. Replacing a worn hub restores a solid, centered connection so the basket spins smoothly without wobble, slip, or grinding. What it does:
The seal at the bottom of the tub had started to fail. On large loads water would leak so I ordered a new one rubber seal. Getting the trunnion off the transmission shaft was hard as it was calcified and corroded. I used a wire brush to get some of it off and then used a lot of WD-40. The bolt holding the trunnion plate on sheared off when I tried to remove it on one side and the other came out ok (the bolt hole through the trunnion is not threaded so it should slide out once the plate is off... Read more
Oil leaking from agitator or poor spin performance? This washer transmission assembly restores wash and spin cycles. Advanced repair, 2-3 hours.
Transmission seal was not available so I installed a new transmission. Works well. Thank you! Read more
This replacement upper agitator restores the washer's normal wash action by moving clothes and improving water circulation for better cleaning. It fits the factory agitator location and replaces worn, cracked, or damaged agitators to restore performance. What it does:
Replaced the damaged agitator with a new one. After watching the youTube video from this website. Read more
This washer switch is both the lid lock and lid switch. New mounting bracket replaces older design. Which means in some applications you may need to drill off old design mounting bracket prior to mounting the new lock. If your replacing the 4 wire switch you will need to tape off light switch leads. The light will no longer be used. Instructions included.
I unplugged the power source to the appliance. I unscrewed 2 screws and unplugged the lid switch. I replaced the old switch with the new switch and screwed in the same 2 screws that held the old switch in place and plugged the new lid switch back in under the lid. that's it . I plugged in the washer and started a load of clothes. works just fine. NO HUGE REPAIR BILL. Gosh it makes me happy to do such a simple repair to my old machine and for a very reasonable part price, my washer is... Read more
Replaced myself. Read more
White
Easily found needed part via appliance maker and photo on APP. Read more
Color: white. It measures about 3-1/2 inches in diameter, and 2-1/2 inches high.
Ordered rear drum bearing kit and watched video on how to replace it. I completed the job in 2 hours, it took awhile for me to figure out which screws had to be removed as I have the small washer/dryer combo that dryer sits on top. Once replaced, put back together and ran it for a test run and it was quiet. Thank you, the video helped, especially in using the grease supplied to hold ball bearing and to grease bearing(last time I only ordered the bearing and didn't know to use grease. Read more