Need Help?
Call
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
This right-side end cap is the molded exterior trim piece that finishes the appliance cabinet and protects internal edges. It restores a clean, finished appearance and helps keep door and panel seams sealed from dirt and moisture. What it does:
Usually ships within 4 - 14 days
Replacement screw for securing dryer components like drum supports, panels, and housings. Needed when screws are lost, stripped, or damaged during repair.
Replaced front dryer drum support and lint trap duct as both were disintegrating with multiple cracks. While not as easy for me as in the videos, as placement required a little more jostling of the parts to place and fit snugly, the videos were amazingly helpful and I would never have accomplished the repair without them. I used a Phillips head and a screwdriver. Great experience dealing with customer service as well, as 2 extra wires were sent with the lint trap assembly which my older model... Read more
The Handle Door is an OEM part for GE dryers. This door handle allows for easy opening and closing of the dryer door, providing a secure grip to access the drum.
Common causes for door handle failure include regular wear from frequent use, forceful handling, and material fatigue over time.
Symptoms of a failing Handle Door include:
This OEM GE part is also compatible with Hotpoint, RCA, and some Kenmore models.
Ordered new part Read more
It was fast and simple. Pulled off the old one and snapped the new one in place. Took only a couple of minutes. Read more
Replaced defective parts Read more
Replaced cycling thermostat and two limit switches. Read more
Replaced new parts with the new one, swapping one wire at the time. Read more
Replaces a cracked, rusted, or disconnected exhaust duct that routes hot air from your dryer to the home vent. Restores proper airflow and venting.
Removed front of dryer and back access plate allowing me to see that the pipe just slipped over the blower. A small tab in the back cover was inserted inside the left side of the pipe and when I straightened the tab I could move the pipe to the right and then straight out. Replacement of the pipe was the reverse. The new pipe did not have a hole for the tab, so I bent the tab to its original position, and rested the pipe against the tab. The new pipe had a rear flange that kept it in place.... Read more
This motor plate is the stamped metal mounting plate that secures the motor assembly and keeps it aligned for smooth operation. It restores proper motor positioning and reduces vibration-caused noise or wear. What it does:
Front bracket and leveling screw assembly.
Gas dryer application
I disassembled the dryer to get to the inner rear so that I could disconnect the old cord and replace it with the new cord. The disassembly process was long about 40 mins (first timer) but not very difficult. The replacement process was extremely easy and the reassembly process took about 10 mins. Read more
By continuing to use our site, you agree to our Terms of Usage and Privacy Policy. You can learn more about how we use cookies by reviewing our Privacy Policy.
We use cookies to optimize website functionality, analyze the performance, and provide personalized experience to you. Use the controls below to manage your privacy preferences.
Cross-Site Advertising
When enabled, we may use cookies and similar technologies to deliver personalized advertisements based on your browsing activity across different websites. Opting out will disable third-party advertising cookies on this site.
Analytics Sharing
When enabled, we may share anonymized browsing and usage data with third-party analytics providers to help us understand how visitors use our site. Opting out will prevent this data from being shared with third parties.