Ge Mwf Filter Parts

Cable retainer for washers. Secures and holds cables in place during operation. Replace if cracked, broken, or missing to properly support wiring.

Small mounting clip that secures internal washer components to prevent movement and vibration. Replace if broken, missing, or worn to maintain alignment.

A direct-replacement diverter that routes wash water to the correct spray arms for reliable cleaning performance. Restores proper water direction so dishes get the rinse and wash coverage they need. What it does:

• Directs incoming wash water to the appropriate spray arm(s) during different wash cycles
• Helps maintain proper spray pattern and cleaning performance
• Commonly replaced when spray arms are not receiving water or wash coverage is uneven
• Works with the dishwasher's built-in plumbing to help sequence water flow

• Disconnect power and water supply before starting any repair
• Inspect surrounding hoses and seals; replace any damaged components to prevent leaks
• Minimal mechanical skill required; for exact location and routing

This water level pressure switch senses air pressure from the tub and signals the control to stop filling at the correct level. Replacing a weak or failed switch restores proper filling, helps prevent over/underfilling, and allows cycles to advance.

• Monitors tub water level via the pressure hose and sends the level signal to the control
• Stops water flow at the target level so wash, rinse, and spin can begin
• Common symptoms of a failing switch: continuous filling, overfilling or underfilling, cycle won't advance past fill/sensing, or stops with water still in the tub
• A cracked, kinked, or blocked pressure hose can mimic switch failure—inspect during diagnosis

• Disconnect power and turn off water supply before servicing
• Access the switch from the console/top or rear panel per your model; note wire orientation
• Transfer and firmly seat the pressure hose; inspect it for kinks, cracks, or blockages and replace if damaged
• After installation, run a fill test; some models may require a diagnostic calibration—see the tech sheet or user manual

This drawer hook is the retainer that keeps an appliance drawer securely seated while still allowing easy release for cleaning or service. Replacing a worn or broken hook restores smooth, reliable drawer operation.

• Secures the drawer in its housing so it stays closed during use
• Acts as the catch/release point for removing the drawer when needed
• Helps maintain proper alignment for smooth opening and closing
• Common symptoms: drawer won't stay closed, pops open or falls out, won't latch, or the hook is visibly cracked/missing

• Disconnect power before servicing
• Fully open and remove the drawer to access the hook area
• Align the new hook with the slots/tabs and snap or seat it into place
• Avoid forcing components; refer to the service manual for model-specific steps

Color: White. Measures about 2 inches in diameter. For black order W10129067. For ocean sapphire order W10182079.

This is the inner tub or spin basket that holds clothes during the wash and spin cycles. It rotates at high speed to extract water from laundry and features small perforations that allow water to drain out. Replace this basket if it has cracks, chips, excessive rust, or if clothes are getting snagged or torn during washing.