Need Help?
Call or text
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
Rubber grommet seals the ice maker fill tube where it enters the refrigerator cabinet. Replace if cracked, brittle, leaking, or missing to restore seal.
Replaced original (18 yrs.) 1/4" plastic tubing, clamp and grommet (AppliancePartsPros/GE parts) from outlet of ice maker water control valve to ice maker inlet. Also replaced water supply line to inlet of water control valve with new, GE braided, PEX 1/4" supply line with pre-attached female compression fittings on both ends. Repair job with AppliancePartsPros parts from outlet of water control valve went perfectly well, was simple, and had no leaks when tested. Parts were easy to install,... Read more
Fix a warm fridge with frozen evaporator coils. This defrost heater assembly melts frost buildup to restore proper cooling. Moderate DIY difficulty.
Isolated the problem to extreme frost build up on the evaporator coils. I measured an open circuit on the defrost heater/thermostat, so I ordered both. Following the procedure in the GE service manual for this refrigerator, I gained access to the evaporator in the back of the freezer section, and I replaced the both heater element and the defrost thermostat. Refrigerator cools fine now. The most unexpected thing was how quickly the parts came. They arrived at my front door 18 hours after... Read more
This evaporator fan motor dust cap is an authentic OEM replacement part found on refrigerator and freezer fan motors. This dust cap prevents the fan motor bearing and housing from being damaged by dirt and debris. If the dust cap is cracked or broken, the fan may make loud squealing noises. If the dust cap is not removed and replaced, the fan could stop working and ultimately cause the refrigerator's temperature to be affected. To start, disconnect the power and water to the refrigerator. Remove food from the freezer so that the back panel of the freezer can be accessed to reach the fan. Remove the ice maker and set it outside the freezer. Disconnect the fan and take it out of the freezer to expose the fan's shaft and the dust cover. Pry the dust cover off and install the new one. Replace the fan and cover. Reconnect the wires and reinstall the icemaker. Put the food back in the freezer. Reconnect the power and water.The evaporator fan motor dust cap is a white plastic part that is sold individually. This dust cover is made for use in refrigerators manufactured by General Electric, Hotpoint, and Kenmore.
Replacement of the evaporator fan motor, fan blade, and grommets. The amount of disassembly to reach the part took most of the effort Read more
Replace your refrigerator door gasket to restore the airtight seal and prevent cold air loss. Install when gasket is cracked or loose. Confirm fit.
I ordered a new set of gaskets and filter from Appliance Pros.com. Watched a video on changing the gaskets and got it done. Read more
Refrigerator door gasket creates an airtight seal to keep cold air in. Replace if door won't seal, frost builds up, or gasket is torn. Confirm fit with model.
Replaced with new. Read more
Protective grille cover that mounts over the temperature sensor in your refrigerator. Replace if cracked, broken, or missing to properly shield the sensor.
Common theme on the blogs was thermistors and or defrost heater/thermostat. Ran self-diagnostics which turned on defrost heater which was fine. All five thermistors indicated ok on diagnostic also, but I read more than one time "replace the thermistors no matter what if your FF section isn't cooling". So I ordered all five thermistors and defrost limiter thermostat. Received all in 48 hours (great shipping service), took me about three hours to replace all thermistors and thermostat just as... Read more
White plastic clip that secures the rear of refrigerator shelves or drawer rails to the cabinet wall. Replace if cracked, broken, or missing.
I ordered my parts. It was a breeze thanks to appliancepartspros.com. I received the parts the next day. Installed them myself. Read more
Fix blank displays, inaccurate temperature readings, or unresponsive controls. This control board regulates cooling cycles and monitors sensors. Moderate DIY.
Replaced the refrigerator control board. Read more
This screw is a genuine General Electric part, sold individually. This screw can be used as a replacement part for a refrigerator. A screw can suffer damage in the lifespan of a refrigerator. It can also be easily lost or misplaced. Screws are small parts and are usually installed in multiples to ensure components are reliably attached, so one screw loosening or going missing might not necessarily affect the operability of the refrigerator. However, if the components loosen or the screw suffers damage that strips the part, such as punctures or erosion to the metal material from general wear and tear or from a direct impact, the screw should be removed and replaced with this genuine OEM replacement part. This is an OEM part sourced directly from the manufacturer, and it is sold individually. This screw is compatible with the following appliance brands: General Electric, Hotpoint, RCA, and Americana.
I ordered new parts from appliance parts pros I had the parts the next day and they were very easy to install Read more
Replaces broken or cracked divider guide components in your refrigerator freezer. Restores smooth sliding and secure positioning of adjustable dividers.
Online with appliance parts .com Was able to attain pqrts necessary to fix Read more
Replace worn refrigerator door gasket to restore airtight seal, prevent warm air entry, reduce frost, and maintain stable temperatures. Verify fit.
Fixes refrigerator temperature issues and cooling failures. Replaces faulty control board causing warm compartments or compressor problems. 45-minute DIY fix.
Replace the inverter and pc board noticed the pc board had a bulging capacitor so replaced it while I was at it. Both were simple fixes. Taking less than 45 total. Read more
Refrigerator not cooling or compressor clicking on and off? This compressor kit restores cooling. Requires certified technician with specialty tools.
Replace your cracked or missing crisper cover to restore stable shelf support above vegetable drawers. Confirm fit with your model number before ordering.
Replaced the veg pan cover. Needed to use Allen wrench. Read more
Forms an airtight seal around your refrigerator door to maintain stable temperatures and prevent frost buildup. Replace when worn, torn, or no longer sealing properly.
Holds and guides the crisper drawer for smooth operation. Replace if cracked, broken, or causing drawer misalignment. Mounts inside the refrigerator cavity.
Ordered the new parts on Thursday and they were delivered Saturday. Read more